Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitor for harmonic-filters applications

IEC 60358-3:2013 applies to AC or DC single-phase coupling capacitor, with rated voltage higher than 1 000 V, connected line to ground with the low voltage terminal either permanently earthed or connected to a tuning device for harmonic-filters applications. It replaces Clause 1 of IEC 60358-1:2012. Keywords: AC or DC single-phase coupling capacitor
This publication is to be read in conjunction with IEC 60358-1:2012.

Condensateurs de couplage et diviseurs capacitifs - Partie 3: Condensateur de couplage à courant alternatif ou à courant continu pour des applications à filtres harmoniques

L'IEC 60358-3:2013 s'applique aux condensateurs de couplage monophasés à courant alternatif ou à courant continu, de tension assignée supérieure à 1 000 V, connectés entre la ligne et la terre, avec la borne basse tension connectée de manière permanente à la terre ou connectée à un dispositif d'accord pour des applications à filtres harmoniques. Il remplace l'Article 1 de la CEI 60358-1:2012. Mots clés: condensateurs de couplage monophasés à courant alternatif ou à courant continu
Cette publication doit être lue conjointement avec la CEI 60358-1:2012.

General Information

Status
Published
Publication Date
26-Nov-2013
Current Stage
PPUB - Publication issued
Start Date
15-Feb-2014
Completion Date
27-Nov-2013
Ref Project

Buy Standard

Standard
IEC 60358-3:2013 - Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitor for harmonic-filters applications
English and French language
29 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)


IEC 60358-3 ®
Edition 1.0 2013-11
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
Coupling capacitors and capacitor dividers –
Part 3: AC or DC coupling capacitor for harmonic-filters applications

Condensateurs de couplage et diviseurs capacitifs –
Partie 3: Condensateur de couplage à courant alternatif ou à courant continu
pour des applications à filtres harmoniques
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester.
If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,
please contact the address below or your local IEC member National Committee for further information.

Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni
utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie et les
microfilms, sans l'accord écrit de la CEI ou du Comité national de la CEI du pays du demandeur.
Si vous avez des questions sur le copyright de la CEI ou si vous désirez obtenir des droits supplémentaires sur cette
publication, utilisez les coordonnées ci-après ou contactez le Comité national de la CEI de votre pays de résidence.

IEC Central Office Tel.: +41 22 919 02 11
3, rue de Varembé Fax: +41 22 919 03 00
CH-1211 Geneva 20 info@iec.ch
Switzerland www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.

Useful links:
IEC publications search - www.iec.ch/searchpub Electropedia - www.electropedia.org
The advanced search enables you to find IEC publications The world's leading online dictionary of electronic and
by a variety of criteria (reference number, text, technical electrical terms containing more than 30 000 terms and
committee,…). definitions in English and French, with equivalent terms in
It also gives information on projects, replaced and additional languages. Also known as the International
withdrawn publications. Electrotechnical Vocabulary (IEV) on-line.

IEC Just Published - webstore.iec.ch/justpublished Customer Service Centre - webstore.iec.ch/csc
Stay up to date on all new IEC publications. Just Published If you wish to give us your feedback on this publication
details all new publications released. Available on-line and or need further assistance, please contact the
also once a month by email. Customer Service Centre: csc@iec.ch.

A propos de la CEI
La Commission Electrotechnique Internationale (CEI) est la première organisation mondiale qui élabore et publie des
Normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.

A propos des publications CEI
Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possédez
l’édition la plus récente, un corrigendum ou amendement peut avoir été publié.

Liens utiles:
Recherche de publications CEI - www.iec.ch/searchpub Electropedia - www.electropedia.org
La recherche avancée vous permet de trouver des Le premier dictionnaire en ligne au monde de termes
publications CEI en utilisant différents critères (numéro de électroniques et électriques. Il contient plus de 30 000
référence, texte, comité d’études,…). termes et définitions en anglais et en français, ainsi que
Elle donne aussi des informations sur les projets et les les termes équivalents dans les langues additionnelles.
publications remplacées ou retirées. Egalement appelé Vocabulaire Electrotechnique
International (VEI) en ligne.
Just Published CEI - webstore.iec.ch/justpublished
Service Clients - webstore.iec.ch/csc
Restez informé sur les nouvelles publications de la CEI.
Just Published détaille les nouvelles publications parues. Si vous désirez nous donner des commentaires sur
Disponible en ligne et aussi une fois par mois par email. cette publication ou si vous avez des questions
contactez-nous: csc@iec.ch.
IEC 60358-3 ®
Edition 1.0 2013-11
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
Coupling capacitors and capacitor dividers –

Part 3: AC or DC coupling capacitor for harmonic-filters applications

Condensateurs de couplage et diviseurs capacitifs –

Partie 3: Condensateur de couplage à courant alternatif ou à courant continu

pour des applications à filtres harmoniques

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
CODE PRIX N
ICS 29.120.99; 29.240.99 ISBN 978-2-8322-1274-5

– 2 – 60358-3 © IEC:2013
CONTENTS
FOREWORD . 3
INTRODUCTION . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions. 6
4 Service conditions . 7
5 Ratings . 7
6 Design requirements . 7
7 Test conditions . 7
8 Classification of tests . 7
9 Routine tests . 8
10 Type tests . 10
11 Special tests – Mechanical strength test . 11
12 Marking of the equipment . 11
Annex AA Typical diagram of a filter capacitor . 12
Annex BB (informative) High-frequency characteristics of filter capacitors . 13
Bibliography . 15

Figure 300 – Connection for voltage test of tuning device . 9
Figure AA.1 – Example of a diagram for a filter capacitor (with and without low voltage
terminal) . 12
Figure AA.2 – Example of a diagram for a filter capacitor with tuning device . 12
Figure BB.1 – Wiring diagram of the measuring circuit for the high frequency
capacitance and equivalent series resistance of a coupling capacitor . 14
Figure BB.2 – Relation between length and capacitance where capacitive deviation –
20/+50 % can be fulfilled up to 500 kHz . 14

Table 300 – Marking of the rating plate . 11

60358-3 © IEC:2013 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
COUPLING CAPACITORS AND CAPACITOR DIVIDERS –

Part 3: AC or DC coupling capacitor
for harmonic-filters applications

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 60358-3 has been prepared by IEC technical committee 33: Power
capacitors and their applications.
The text of this standard is based on the following documents:
CDV Report on voting
33/510/CDV 33/526/RVC
Full information on the voting for the approval of this standard can be found in the report on
voting indicated in the above table.
This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.

– 4 – 60358-3 © IEC:2013
A list of all parts in the IEC 60358 series, published under the general title Coupling
capacitors and capacitor dividers, can be found on the IEC website.
This standard is Part 3 of IEC 60358, published under the general title Coupling capacitor
and capacitor dividers.
This International Standard is to be used in conjunction with the latest edition of
IEC 60358-1:2012 and its amendments. It was established on the basis of the first edition
(2012) of that standard.
This Part 3 supplements or modifies the corresponding clauses in IEC 60358-1:2012.
When a particular subclause of Part 1 is not mentioned in this Part 3, that subclause applies
as far as is reasonable. When this standard states “addition”, “modification” or “replacement”,
the relevant text in Part 1 is to be adapted accordingly.
For additional clauses, subclauses, figures, tables or annexes, the following numbering
system is used:
 subclauses, tables and figures which are additional to those in Part 1 are numbered
starting from 300;
 additional tables or annexes are lettered AA, BB, etc.
 as the notes are integrated into the clauses, their numbering starts from 1 as usual.
The committee has decided that the contents of this publication will remain unchanged until
the stability date indicated on the IEC web site under "http://webstore.iec.ch" in the data
related to the specific publication. At this date, the publication will be
 reconfirmed,
 withdrawn,
 replaced by a revised edition, or
 amended.
IMPORTANT – The “colour inside” logo on the cover page of this publication indicates
that it contains colours which are considered to be useful for the correct
understanding of its contents. Users should therefore print this publication using a
colour printer.
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.