EN IEC 60335-2-102:2024

SLOVENSKI STANDARD
01-januar-2025
Nadomešča:
SIST EN 60335-2-102:2016
Gospodinjski in podobni električni aparati - Varnost - 2-102. del: Posebne zahteve
za aparate na plin, olje in trdna goriva z električnimi priključki (IEC 60335-2-
102:2017)
Household and similar electrical appliances - Safety - Part 2-102: Particular requirements
for gas, oil and solid-fuel burning appliances having electrical connections (IEC 60335-2-
102:2017)
Sicherheit elektrischer Geräte für den Hausgebrauch und ähnliche Zwecke - Teil 2-102:
Besondere Anforderungen für Gas-, Öl- und Festbrennstoffgeräte mit elektrischen
Anschlüssen (IEC 60335-2-102:2017)
Appareils électrodomestiques et analogues - Sécurité - Partie 2-102: Règles particulières
pour les appareils à combustion au gaz, au mazout et à combustible solide comportant
des raccordements électriques (IEC 60335-2-102:2017)
Ta slovenski standard je istoveten z: EN IEC 60335-2-102:2024
ICS:
13.120 Varnost na domu Domestic safety
97.100.20 Plinski grelniki Gas heaters
97.100.30 Grelniki na trdo gorivo Solid fuel heaters
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD EN IEC 60335-2-102

NORME EUROPÉENNE
EUROPÄISCHE NORM November 2024
ICS 13.120; 97.100.20; 97.100.30 Supersedes EN 60335-2-102:2016
English Version
Household and similar electrical appliances - Safety - Part 2-102:
Particular requirements for gas, oil and solid-fuel burning
appliances having electrical connections
(IEC 60335-2-102:2017)
Appareils électrodomestiques et analogues - Sécurité - Sicherheit elektrischer Geräte für den Hausgebrauch und
Partie 2-102: Exigences particulières pour les appareils à ähnliche Zwecke - Teil 2-102: Besondere Anforderungen für
combustion au gaz, au mazout et à combustible solide Gas-, Öl- und Festbrennstoffgeräte mit elektrischen
comportant des raccordements électriques Anschlüssen
(IEC 60335-2-102:2017) (IEC 60335-2-102:2017)
This European Standard was approved by CENELEC on 2024-08-07. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.

European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2024 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 60335-2-102:2024 E

European foreword
This document (EN IEC 60335-2-102:2024) consists of the text of document IEC 60335-2-102:2017,
prepared by IEC/TC 61 "Safety of household and similar electrical appliances".
The following dates are fixed:
• latest date by which this document has to be (dop) 2025-05-15
implemented at national level by publication of an
identical national standard or by endorsement
• latest date by which the national standards (dow) 2027-11-15
conflicting with this document have to be withdrawn
This document supersedes EN 60335-2-102:2016 and all of its amendments and corrigenda (if any).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document is read in conjunction with EN IEC 60335-2-102:2024/A11:2024.
This document has been prepared under a standardization request addressed to CENELEC by the
European Commission. The Standing Committee of the EFTA States subsequently approves these
requests for its Member States.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 60335-2-102:2017 was approved by CENELEC as a
European Standard without any modification.

IEC 60335-2-102 ®
Edition 2.0 2017-12
INTERNATIONAL
STANDARD
Household and similar electrical appliances – Safety –

Part 2-102: Particular requirements for gas, oil and solid-fuel burning appliances

having electrical connections
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
ICS 97.100.20, 97.100.30, 13.120 ISBN 978-2-8322-4843-0

– 2 – IEC 60335-2-102:2017  IEC 2017
CONTENTS
FOREWORD . 3
INTRODUCTION . 5
1 Scope . 6
2 Normative references . 7
3 Terms and definitions . 7
4 General requirement . 7
5 General conditions for the tests . 7
6 Classification . 8
7 Marking and instructions . 8
8 Protection against access to live parts . 8
9 Starting of motor-operated appliances . 9
10 Power input and current . 9
11 Heating . 9
12 Void . 9
13 Leakage current and electric strength at operating temperature . 9
14 Transient overvoltages . 9
15 Moisture resistance . 9
16 Leakage current and electric strength . 10
17 Overload protection of transformers and associated circuits . 11
18 Endurance . 11
19 Abnormal operation . 11
20 Stability and mechanical hazards . 11
21 Mechanical strength . 11
22 Construction . 12
23 Internal wiring . 13
24 Components . 13
25 Supply connection and external flexible cords . 13
26 Terminals for external connections . 13
27 Provision for earthing . 13
28 Screws and connections . 13
29 Clearances, creepage distances and solid insulation . 13
30 Resistance to heat and fire . 14
31 Resistance to rusting . 14
32 Radiation, toxicity and similar hazards . 14
Annexes . 15
Bibliography . 16

Figure 101 – Pulse waveform . 14

Table 101 – Accessible spark-ignition circuit limits . 8

IEC 60335-2-102:2017  IEC 2017 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES –
SAFETY –
Part 2-102: Particular requirements for gas, oil and solid-fuel
burning appliances having electrical connections

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 60335-2-102 has been prepared by IEC technical committee 61:
Safety of household and similar electrical appliances.
This second edition cancels and replaces the first edition published in 2004 including its
Amendment 1 (2008) and its Amendment 2 (2012). This edition constitutes co
...