EN IEC 60335-2-37:2024/A11:2024

SLOVENSKI STANDARD
01-januar-2025
Gospodinjski in podobni električni aparati - Varnost - 2-37. del: Posebne zahteve
za komercialne električne cvrtnike - Dopolnilo A11
Household and similar electrical appliances - Safety - Part 2-37: Particular requirements
for commercial electric doughnut fryers and deep fat fryers
Sicherheit elektrischer Geräte für den Hausgebrauch und ähnliche Zwecke - Teil 2-37:
Besondere Anforderungen für elektrische Fettbackgeräte und Fritteusen für den
gewerblichen Gebrauch
Appareils électrodomestiques et analogues – Sécurité – Partie 2-37: Règles particulières
pour les friteuses et les friteuses à beignets électriques à usage collectif
Ta slovenski standard je istoveten z: EN IEC 60335-2-37:2024/A11:2024
ICS:
97.040.50 Majhni gospodinjski aparati Small kitchen appliances
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD EN IEC 60335-2-37:2024/A11

NORME EUROPÉENNE
EUROPÄISCHE NORM November 2024
ICS 97.040.50
English Version
Household and similar electrical appliances - Safety - Part 2-37:
Particular requirements for commercial electric doughnut fryers
and deep fat fryers
Appareils électrodomestiques et analogues - Sécurité - Sicherheit elektrischer Geräte für den Hausgebrauch und
Partie 2-37: Exigences particulières pour les friteuses et les ähnliche Zwecke - Teil 2-37: Besondere Anforderungen für
friteuses à beignets électriques à usage collectif elektrische Fettbackgeräte und Fritteusen für den
gewerblichen Gebrauch
This amendment A11 modifies the European Standard EN IEC 60335-2-37:2024; it was approved by CENELEC on 2024-08-07. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.

European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2024 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 60335-2-37:2024/A11:2024 E

Contents Page
1 Modification to Introduction . 4
2 Modification to Clause 1, “Scope” . 4
3 Modification to Clause 7, “Marking and instructions” . 4
4 Modification to Clause 20, “Stability and mechanical hazards” . 5
5 Modification to Clause 22, “Construction” . 5
6 Modification to annexes. 6
European foreword
This document (EN IEC 60335-2-37:2024/A11:2024) has been prepared by CLC/TC 61 “Safety of
household and similar electrical appliances”.
The following dates are fixed:
• latest date by which this document has (dop) 2025-08-07
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2027-08-07
standards conflicting with this document
have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document is read in conjunction with EN IEC 60335-2-37:2024.
The numbering system for European clauses, subclauses, notes, tables, figures and annexes that are
additional to those in the IEC standard are prefixed with the letter “Z”.
This document has been prepared under a standardization request addressed to CENELEC by the
European Commission. The Standing Committee of the EFTA States subsequently approves these
requests for its Member States.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
1 Modification to Introduction
With this European Amendment A11, the standard EN 60335-2-37:2002+A1:2008+A11:2012+A12:2016
is superseded.
This European Amendment A11 supplements or modifies the corresponding clauses of the standards
below:
— EN 60335-1:2012+A11:2014+A13:2017+A1:2019+A14:2019+A2:2019+A15:2021+A16:2023 (Part 1)
— EN IEC 60335-2-37:2024 (Part 2)
2 Modification to Clause 1, “Scope”
Replace fourth paragraph starting with “As far as is practicable…”, except Note 102 and Note 103, with
the following:
“This document deals with the reasonably foreseeable hazards presented by appliances that are
encountered by all persons in and around the installation place. However, in general, it does not take into
account:
— children playing with the appliance;
— the use of the appliance by children;
It is recognized that very vulnerable people can have needs beyond the level addressed in this
document.”
Add a new bullet point in Note 103:
“—  gas, oil or solid fuel burning appliances (EN IEC 60335-2-102)”
Add as new paragraphs:
“Additional requirements for appliances with power driven moving parts are given in Annex ZE.
This document does not deal with any specific requirements on noise emitted from these appliances the
is
generated noise is not considered to be a relevant hazard. Thus, the emission sound pressure level LpA
≤ 70 dB(A).”
considered to be LpA
3 Modification to Clause 7, “Marking and instructions”
7.12 Modification:
In the ninth paragraph of the addition starting with “if symbol…”, add after “IEC 60417-5021 (2002-10)”
the following “, ISO 7000-0434A (2004-01)”
Add:
The front cover of the instructions shall include the substance of the following:
CAUTION: Read the instructions before using the appliance
This wording may be replaced by symbols ISO 7000-0434A and ISO 7000-0790.
Replace the modification in Part 2 with the following:
This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Add the following:
The instructions shall also state
— the intended use of the appliance as covered by the scope of this document;
— instructions regarding user maintenance and operation of the appliance and, if necessary,
instructions for the training of operators;
— instructions designed to enable adjustment and maintenance to be carried out safely, including the
protective measures that should be taken during these operations;
— the conditions under which the appliance is stable during use, dismantling when out of use, testing or
foreseeable breakdowns;
— the operating method to be followed in the event of accident or breakdown to prevent unsafe actions;
— information regarding the use of personal protection equipment in case of spreading hot food stuff;
— Warning concerning possible slippery floor adjacent to the appliance.
Add the following:
The instructions shall also state the maximum weight of the empty appliance.
7.12.1 Addition:
The instructions shall state that any repairs shall be carried out by competent persons.
The instructions for table-top appliances shall state that a support is needed so that the working height of
the appliance is between 695 and 980 mm.
Add the following subclause:
7.12.Z101
The instructions shall include the possible reasonably foreseeable misuse and, whenever relevant, a
warning against the effects it may have on the safe use of the appliance. At least, it shall include the
substance of the following:
WARNING: Appliances shall be disconnected from their power supply during cleaning or
maintenance and when replacing parts.
Compliance is checked by inspection.
4 Modification to Clause 20, “Stability and mechanical hazards”
20.2 Addition
In the second dashed item starting with “test probe 18 of EN 61032.“, add the following:
Test probe 18 is not applicable unless the appliance is intended to be installed in an area open to the
public
5 Modification to Clause 22, “Construction”
22.13 Add the following after the first paragraph:
Lids shall be equipped with at least one handle. Handles shall be placed in such a way that scalding by
steam is prevented when the lid is opened.
22.48 Addition
After the first paragraph, add the following:
For appliances within the scope of this document without cleaning system, Fluid Category is 2 according
to EN 61770:2009 .
For appliances within the scope of this document with cleaning system, Fluid Category is 3 according to
EN 61770:2009 .
22.113 Add the following as a second paragraph:
This requirement is met, if:
— the hinge incorporates a click stop; or
— the lid is counter balanced; or
— the lid can be opened through an angle of at least 100°.
Add the following new sub clauses:
22.Z.101 Appliances shall meet the following ergonomic requirements
...