EN 60301:2012

SLOVENSKI STANDARD
01-december-2012
1DGRPHãþD
SIST HD 349 S1:2004
3UHIHUHQþQLSUHPHULåLþQLKSULNOMXþNRYNRQGHQ]DWRUMHYLQXSRURY
Preferred diameters of wire terminations of capacitors and resistors
Valeurs préférentielles des diamètres des fils de sorties des condensateurs et
résistances
Ta slovenski standard je istoveten z: EN 60301:2012
ICS:
31.040.01 Upori splošno Resistors in general
31.060.01 Kondenzatorji na splošno Capacitors in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 60301
NORME EUROPÉENNE
October 2012
EUROPÄISCHE NORM
ICS 31.040; 31.060 Supersedes HD 349 S1:1977

English version
Preferred diameters of wire terminations of capacitors
and resistors
(IEC 60301:2012)
Valeurs préférentielles des diamètres  Bevorzugte Durchmesser
des fils de sorties des condensateurs für Anschlussdrähte an Kondensatoren
et résistances und Widerständen
(CEI 60301:2012) (IEC 60301:2012)

This European Standard was approved by CENELEC on 2012-08-17. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels

© 2012 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60301:2012 E
Foreword
The text of document 40/2153/FDIS, future edition 3 of IEC 60301, prepared by IEC/TC 40
"Capacitors and resistors for electronic equipment" was submitted to the IEC-CENELEC parallel vote
and approved by CENELEC as EN 60301:2012.
The following dates are fixed:
(dop) 2013-05-17
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
(dow) 2015-08-17
• latest date by which the national
standards conflicting with the
document have to be withdrawn
This document supersedes HD 349 S1:1977.

- employment of SI units only in the normative part of this standard, causing transfer of all imperial
dimensions from Table 1 to the informative Annex A;
- addition of two smaller diameters of wire terminations in Table 1; and
- tightening of the tolerance ranges defined by minimum and maximum diameters in Table 1.

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.
Endorsement notice
The text of the International Standard IEC 60301:2012 was approved by CENELEC as a European
Standard without any modification.

IEC 60301 ®
Edition 3.0 2012-07
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Preferred diameters of wire terminations of capacitors and resistors

Valeurs préférentielles des diamètres des fils de sorties des condensateurs et

résistances
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
CODE PRIX F
ICS 31.040; 31.060 ISBN 978-2-83220-225-8

– 2 – 60301 © IEC:2012
CONTENTS
FOREWORD . 3
1 Scope . 5
2 Preferred diameters of wire terminations . 5
Annex A (informative) Imperial wire dimensions . 6

Table 1 – Preferred diameters of wire terminations . 5
Table A.1 – Typical imperial wire diameters . 6

60301 © IEC:2012 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
PREFERRED DIAMETERS OF WIRE TERMINATIONS
OF CAPACITORS AND RESISTORS
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Sp
...