EN ISO 11105:2017

SLOVENSKI STANDARD
01-november-2017
1DGRPHãþD
SIST EN ISO 11105:2000
0DODSORYLOD=UDþHQMHEHQFLQVNHJDPRWRUMDLQDOLSURVWRURY]DEHQFLQVNLWDQN,62

Small craft - Ventilation of petrol engine and/or petrol tank compartments (ISO
11105:1997)
Kleine Wasserfahrzeuge - Belüftung von Räumen mit Ottomotoren und/oder Benzintanks
(ISO 11105:1997)
Navires de plaisance - Ventilation des compartiments moteur à essence et/ou réservoir à
essence (ISO 11105:1997)
Ta slovenski standard je istoveten z: EN ISO 11105:2017
ICS:
47.020.20 Ladijski motorji Marine engines and
propulsion systems
47.080 ýROQL Small craft
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN ISO 11105
EUROPEAN STANDARD
NORME EUROPÉENNE
September 2017
EUROPÄISCHE NORM
ICS 47.080 Supersedes EN ISO 11105:1997
English Version
Small craft - Ventilation of petrol engine and/or petrol
tank compartments (ISO 11105:1997)
Navires de plaisance - Ventilation des compartiments Kleine Wasserfahrzeuge - Belüftung von Räumen mit
moteur à essence et/ou réservoir à essence (ISO Ottomotoren und/oder Benzintanks (ISO 11105:1997)
11105:1997)
This European Standard was approved by CEN on 23 July 2017.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 11105:2017 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
Annex ZA (informative) Relationship between this European Standard and the essential
requirements of Directive 2013/53/EU aimed to be covered . 4
European foreword
The text of ISO 11105:1997 has been prepared by Technical Committee ISO/TC 188 “Small craft” of the
International Organization for Standardization (ISO) and has been taken over as EN ISO 11105:2017.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by March 2018, and conflicting national standards shall be
withdrawn at the latest by March 2018.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 11105:1997.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this
document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands,
Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
the United Kingdom.
Endorsement notice
The text of ISO 11105:1997 has been approved by CEN as EN ISO 11105:2017 without any modification.
Annex ZA
(informative)
Relationship between this European Standard and the essential
requirements of Directive 2013/53/EU aimed to be covered
This European Standard has been prepared under a Commission’s standardization request
M/542/C(2015) 8736 final to provide one voluntary means of conforming to essential requirements of
Directive 2013/53/EU.
Once this standard is cited in the Official Journal of the European Union under that Directive, compliance
with the normative clauses of this standard given in Table ZA.1 confers, within the limits of the scope of
this standard, a presumption of conformity with the corresponding essential requirements of that
Directive, and associated EFTA regulations.
Table ZA.1 — Correspondence between this European Standard and
Annex I of Directive 2013/53/EU
Essential Requirements of Clause(s)/sub-clause(s) Remarks/Notes
Directive 2013/53/EU of this EN
Annex I.A.2.5 - Owner's manual 7
Annex I.A.5.1.2 – Installation 3, 4, 5, 6 These clauses of this standard
requirements, ventilation of address the ventilation
engine compartments requirements for petrol engine
compartments only. They do not
address the risk of downflooding
and sinking through ventilation
openings as required by Annex
I.A.3.5 (b) – Flooding.
Annex I.A.5.2.2 – Fuel system, 3, 4, 5, These clauses of this standard
fuel tanks address the ventilation
requirements for petrol tank
compartments only.
WARNING 1 — Presumption of conformity stays valid only as long as a reference to this European
Standard is maintained in the list published in the Official Journal of the European Union. Users of this
standard should consult frequently the latest list published in the Official Journal of the European Union.
WARNING 2 — Other Union legislation may be applicable to the product(s) falling within the scope of
this standard.
INTERNATIONAL IS0
STANDARD 11105
Second edition
1997-05 15
Small craft - Ventilation of petrol engine
and/or petrol tank compartments
Navires de plaisance - Ventilation des compafliments moteur ZI essence
etloer rhervoir ti essence
Reference number
IS0 11105: 1997(E)
IS0 11105:1997(E)
Foreword
IS0 (the International Organization for Standardization) is a worldwide
federation of national standards bodies (IS0 member bodies). The work of
preparing International Standards is normally carried out through IS0
technical committees. Each member body interested in a subject for which
a technical committee has been established has the right to be represented
on that committee. International organizations, governmental and non-
governmental, in liaison with ISO, also take part in the work. IS0
collaborates closely with the International Electrotechnical Commission
(IEC) on all matters of electrotechnical standardization.
Draft International Standards adopted by the technical committees are
circulated to the member bodies for voting. Publication as an International
Standard requires approval by at least 75 % of the member bodies casting
a vote.
International Standard IS0 11105 was prepared by Technical Committee
tSO/TC 188, Small craft.
This second edition cancels and replaces the first edition
(IS0 11105:1995), definition 3.2, subclauses 4.3.1 and 4.3.2, of which have
been deleted. Additionally, subclause 4.4 and figure 1 have been
amended.
Annex A of this International Standard is for information only.
0 IS0 1997
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced
or utilized in any form or by any means, electronic or mechanical, including photocopying and
microfilm, without permission in writing from the publisher.
International Organization for Standardization
Case postale 56 l Cl-l-121 1 Gen&e 20 l Switzerland
Internet: central @ iso.ch
x.400: c=ch; a=400net; p=iso; o=isocs; s=central
Printed in Switzerland
ii
INTERNATIONAL STANDARD o Is0 IS0 11105:1997(E)
Small craft - Ventilation of petrol engine and/or petrol tank
compartments
1 Scope
This International Standard specifies requirements for ventilation of petrol engine and petrol tank compartments in
small craft of up to 24 m length of hull, having petrol engines for propulsion, electrical generation or mechanical
power, to prevent accumulation of explosive gases in these compartments. Personal watercraft are not covered.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this
International Standard. At the time of publication, the editions indicated were valid. All standards are subject to
revision, and parties to agreements based on this International Standard are encouraged to investigate the
possibility of applying the most recent editions of the standards listed below. Members of IEC and IS0 maintain
registers of currently valid International Standards.
IS0 8846:1990, Small craft - Electrical devices - Protection against ignition of surrounding flammable gases.
IS0 9097:1991, Small craft - Electric fans.
IS0 11192:- 1 ), Small craft - Graphical symbols.
3 Definit
...