EN 1501-2:2005/FprA1

SLOVENSKI STANDARD
01-junij-2009
9R]LOD]D]ELUDQMHRGSDGNRYLQSULSDGDMRþLL]WUHVDOQLNL6SORãQHLQYDUQRVWQH
]DKWHYHGHO9R]LOD]D]ELUDQMHRGSDGNRY]QDNODGDQMHPVVWUDQL
Refuse collection vehicles and associated lifting devices - General requirements and
safety requirements - Part 2: Side loaded refuse collection vehicles
Abfallsammelfahrzeuge und die dazugehörigen Schüttungen - Allgemeine
Anforderungen und Sicherheitsanforderungen - Teil 2: Seitenlader
Bennes de collecte des déchets et leurs lève-conteneurs associés - Exigences générales
et exigences de sécurité - Partie 2: Bennes à chargement latéral
Ta slovenski standard je istoveten z: EN 1501-2:2005/FprA1
ICS:
43.160 Vozila za posebne namene Special purpose vehicles
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
FINAL DRAFT
EN 1501-2:2005
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
April 2009
ICS 43.160
English Version
Refuse collection vehicles and associated lifting devices -
General requirements and safety requirements - Part 2: Side
loaded refuse collection vehicles
Bennes de collecte des déchets et leurs lève-conteneurs Abfallsammelfahrzeuge und die dazugehörigen
associés - Exigences générales et exigences de sécurité - Schüttungen - Allgemeine Anforderungen und
Partie 2: Bennes à chargement latéral Sicherheitsanforderungen - Teil 2: Seitenlader
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 183.
This draft amendment A1, if approved, will modify the European Standard EN 1501-2:2005. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1501-2:2005/FprA1:2009: E
worldwide for CEN national Members.

Contents Page
Foreword .3
1 Modification to Clause 2 .4
2 Modification to Clause 6 .4
3 Modifications to Clause 7 .4
4 Addition of Annex ZB .6

Foreword
This document (EN 1501-2:2005/FprA1:2009) has been prepared by Technical Committee CEN/TC 183
“Waste management”, the secretariat of which is held by DIN.
This document is currently submitted to the Unique Acceptance Procedure.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EC Directive(s).
For relationship with EC Directive(s), see informative Annexes ZA and ZB, which are integral parts of this
document.
1 Modification to Clause 2
Add the following reference:
“EN 1501-4:2007, Refuse collection vehicles and their associated lifting devices – General requirements and
safety requirements — Part 4: Noise test code for
...