SIST EN ISO 105-E12:2012

SLOVENSKI STANDARD
SIST EN ISO 105-E12:2012
01-september-2012
1DGRPHãþD
SIST EN ISO 105-E12:1999
SIST EN ISO 105-E12:1999/A1:2003
Tekstilije - Preskušanje barvne obstojnosti - Del E12: Barvna obstojnost proti
alkalnemu valjanju (ISO 105-E12:2010)
Textiles - Tests for colour fastness - Part E12: Colour fastness to milling: Alkaline milling
(ISO 105-E12:2010)
Textilien - Farbechtheitsprüfungen - Teil E12: Farbechtheit gegen Walken: Alkalische
Walke (ISO 105-E12:2010)
Textiles - Essais de solidité des coloris - Partie E12: Solidité des coloris au foulon:
Foulon alcalin (ISO 105-E12:2010)
Ta slovenski standard je istoveten z: EN ISO 105-E12:2010
ICS:
59.080.01 Tekstilije na splošno Textiles in general
SIST EN ISO 105-E12:2012 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 105-E12:2012

---------------------- Page: 2 ----------------------

SIST EN ISO 105-E12:2012


EUROPEAN STANDARD
EN ISO 105-E12

NORME EUROPÉENNE

EUROPÄISCHE NORM
April 2010
ICS 59.080.01 Supersedes EN ISO 105-E12:1997
English Version
Textiles - Tests for colour fastness - Part E12: Colour fastness
to milling: Alkaline milling (ISO 105-E12:2010)
Textiles - Essais de solidité des coloris - Partie E12: Textilien - Farbechtheitsprüfungen - Teil E12: Farbechtheit
Solidité des coloris au foulon: Foulon alcalin (ISO 105- gegen Walken: Alkalische Walke (ISO 105-E12:2010)
E12:2010)
This European Standard was approved by CEN on 22 March 2010.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.






EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 105-E12:2010: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 105-E12:2012
EN ISO 105-E12:2010 (E)
Contents Page
Foreword .3

2

---------------------- Page: 4 ----------------------

SIST EN ISO 105-E12:2012
EN ISO 105-E12:2010 (E)
Foreword
This document (EN ISO 105-E12:2010) has been prepared by Technical Committee ISO/TC 38 "Textiles" in
collaboration with Technical Committee CEN/TC 248 “Textiles and textile products” the secretariat of which is
held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by October 2010, and conflicting national standards shall be withdrawn at
the latest by October 2010.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 105-E12:1997.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
Endorsement notice
The text of ISO 105-E12:2010 has been approved by CEN as a EN ISO 105-E12:2010 without any
modification.

3

---------------------- Page: 5 ----------------------

SIST EN ISO 105-E12:2012

---------------------- Page: 6 ----------------------

SIST EN ISO 105-E12:2012

INTERNATIONAL ISO
STANDARD 105-E12
Fourth edition
2010-04-15


Textiles — Tests for colour fastness —
Part E12:
Colour fastness to milling: Alkaline
milling
Textiles — Essais de solidité des coloris —
Partie E12: Solidité des coloris au foulon: Foulon alcalin




Reference number
ISO 105-E12:2010(E)
©
ISO 2010

---------------------- Page: 7 ----------------------

SIST EN ISO 105-E12:2012
ISO 105-E12:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2010 – All rights reserved

---------------------- Page: 8 ----------------------

SIST EN ISO 105-E12:2012
ISO 105-E12:2010(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 105-E12 was prepared by Technical Committee ISO/TC 38, Textiles, Subcommittee SC 1, Tests for
coloured textiles and colorants.
This fourth edition cancels and replaces the third edition (ISO 105-E12:1989), which has been technically
revised. It also incorporates ISO 105-E12:1989/Cor.1:2002 and ISO 105-E12:1989/Amd.1:2002
ISO 105 consists of many parts designated by a part letter and a two-digit serial number (e.g. A01), under the
general title Textiles — Tests for colour fastness. A complete list of these parts is given in ISO 105-A01.
© ISO 2010 – All rights reserved iii

---------------------- Page: 9 ----------------------

SIST EN ISO 105-E12:2012

---------------------- Page: 10 ----------------------

SIST EN ISO 105-E12:2012
INTERNATIONAL STANDARD ISO 105-E12:2010(E)

Textiles — Tests for colour fastness —
Part E12:
Colour fastness to milling: Alkaline milling
1 Scope
This part of ISO 105 specifies a method for determining the resistance of the colour of wool and part-wool
textiles to the action of soap and sodium carbonate solutions used in alkaline milling (severe method) or of a
soap solution only (mild method).
The mild method can be applied to light- or medium-weight wool (or wool-containing) clothing fabrics.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 105-A01:2010, Textiles — Tests for colour fastness — Part A01: General principles of testing
ISO 105-A02, Textiles — Tests for colour fastness — Part A02: Grey scale for assessing change in colour
ISO 105-A03, Textiles — Tests for colour fastness — Part A03: Grey scale for assessing staining
ISO 105-A04, Textiles — Tests for colour fastness — Part A04: Method for the instrumental assessment of
the degree of staining of adjacent fabrics
ISO 105-A05, Textiles — Tests for colour fastness — Part A05: Instrumental assessment of change in colour
for determination of grey scale rating
ISO 105-F01, Textiles — Tests for colour fastness — Part F01: Specification for wool adjacent fabric
ISO 105-F02, Textiles — Tests for colour fastness — Part F02: Specification for cotton and viscose adjacent
fabrics
ISO 105-F03, Textiles —Tests for colour fastness — Part F03: Specification for polyamide adjacent fabric
ISO 105-F04, Textiles —Tests for colour fastness — Part F04: Specification for polyester adjacent fabric
ISO 105-F05, Textiles —Tests for colour fastness — Part F05: Specification for acrylic adjacent fabric
ISO 105-F06, Textiles —Tests for colour fastness — Part F06: Specification for silk adjacent fabric
ISO 105-F07, Textiles —Tests for colour fastness — P
...