SIST EN 13445-5:2009/A1:2011
(Amendment)Unfired pressure vessels - Part 5: Inspection and testing
Unfired pressure vessels - Part 5: Inspection and testing
This Part of this European Standard specifies the inspection and testing of individual and serially produced pressure vessels made of steels in accordance with EN 13445-2 predominantly subject to non cyclic operation (i.e. vessels operating below 500 full equivalent pressure cycles).
Special provisions for cyclic operation are given in EN 13445-3 and in Annex G of this Part.
This Part does not give inspection and testing provisions for vessels designed using Design by Analysis - Direct Route (DBA) of Annex B of EN 13445-3:2002.
NOTE The responsibilities of parties involved in the conformity assessment procedures are given in Directive 97/23/EC. Guidance on this can be found in CR 13445-7.
Unbefeuerte Druckbehälter - Teil 5: Inspektion und Prüfung
Récipients sous pression non soumis à la flamme - Partie 5: Inspection et contrôle
Neogrevane tlačne posode - 5. del: Pregled in preskušanje - Dopolnilo A1
Ta del tega evropskega standard določa pregled in preskušanje posamezno in serijsko izdelanih tlačnih posod, narejenih iz jekla, v skladu z EN 13445-2, ki večinoma obratujejo neciklično (tj. posode, ki obratujejo pod 500 polnimi ekvivalenti tlačnih ciklov).
Posebne določbe za ciklično obratovanje so navedene v EN 13445-3 in dodatku G tega dela.
Ta del ne navaja določb za pregled in preskušanje za posode, zasnovane z načrtovanjem z analizo – direktna pot (DBA) iz dodatka B EN 13445-3:2002.
OPOMBA: Odgovornosti vključenih v postopke ocenjevanja skladnosti so navedene v Direktivi 97/23/ES. Navodilo v zvezi s tem je v CR 13445-7.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 13445-5:2009/A1:2011
01-november-2011
1HRJUHYDQHWODþQHSRVRGHGHO 3UHJOHGLQSUHVNXãDQMH'RSROQLOR$
Unfired pressure vessels - Part 5: Inspection and testing
Unbefeuerte Druckbehälter - Teil 5: Inspektion und Prüfung
Récipients sous pression non soumis à la flamme - Partie 5: Inspection et contrôle
Ta slovenski standard je istoveten z: EN 13445-5:2009/A1:2011
ICS:
23.020.30 7ODþQHSRVRGHSOLQVNH Pressure vessels, gas
MHNOHQNH cylinders
SIST EN 13445-5:2009/A1:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 13445-5:2009/A1:2011
---------------------- Page: 2 ----------------------
SIST EN 13445-5:2009/A1:2011
EUROPEAN STANDARD
EN 13445-5:2009/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
July 2011
ICS 23.020.30
English Version
Unfired pressure vessels - Part 5: Inspection and testing
Récipients sous pression non soumis à la flamme - Partie Unbefeuerte Druckbehälter - Teil 5: Inspektion und Prüfung
5: Inspection et contrôles
This amendment A1 modifies the European Standard EN 13445-5:2009; it was approved by CEN on 8 July 2011.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 13445-5:2009/A1:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 13445-5:2009/A1:2011
EN 13445-5:2009/A1:2011 (E)
Contents Page
Foreword .3
1 Modification to 10.2.3.1 Proof test - General .4
2 Modification to Anne
...
SLOVENSKI STANDARD
SIST EN 13445-5:2009/oprA1:2010
01-marec-2010
1HRJUHYDQHWODþQHSRVRGHGHO .RQWURODLQSUHVNXãDQMH
Unfired pressure vessels - Part 5: Inspection and testing
Unbefeuerte Druckbehälter - Teil 5: Inspektion und Prüfung
Récipients sous pression non soumis à la flamme - Partie 5: Inspection et contrôle
Ta slovenski standard je istoveten z: EN 13445-5:2009/prA1
ICS:
23.020.30 7ODþQHSRVRGHSOLQVNH Pressure vessels, gas
MHNOHQNH cylinders
SIST EN 13445-5:2009/oprA1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 13445-5:2009/oprA1:2010
---------------------- Page: 2 ----------------------
SIST EN 13445-5:2009/oprA1:2010
EUROPEAN STANDARD
DRAFT
EN 13445-5:2009
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
November 2009
ICS 23.020.30
English Version
Unfired pressure vessels - Part 5: Inspection and testing
Récipients sous pression non soumis à la flamme - Partie Unbefeuerte Druckbehälter - Teil 5: Inspektion und Prüfung
5: Inspection et contrôle
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 54.
This draft amendment A1, if approved, will modify the European Standard EN 13445-5:2009. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distribu
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.