Processing photographic wastes — Analysis of cyanides — Determination of hexacyanoferrate (II) and hexacyanoferrate (III) by spectrometry

ISO 7766:2003 establishes a test method for the determination of hexacyanoferrate(II) (ferrocyanide) and hexacyanoferrate(III) (ferricyanide), referred to hereafter as Fe(CN)6, in photographic processing effluents. Results are reported as hexacyanoferrate, Fe(CN)6.

Effluents de traitement photographique — Analyse des cyanures — Détermination de l'hexacyanoferrate (II) et de l'hexacyanoferrate (III) par spectrométrie

General Information

Status
Published
Publication Date
18-Jun-2003
Technical Committee
Drafting Committee
Current Stage
9093 - International Standard confirmed
Completion Date
20-Dec-2023
Ref Project

Relations

Buy Standard

Standard
ISO 7766:2003 - Processing photographic wastes -- Analysis of cyanides -- Determination of hexacyanoferrate (II) and hexacyanoferrate (III) by spectrometry
English language
7 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 7766
First edition
2003-06-15

Processing photographic wastes —
Analysis of cyanides — Determination of
hexacyanoferrate(ll) and
hexacyanoferrate(lll) by spectrometry
Effluents de traitement photographiques — Analyse des cyanures —
Détermination de l'hexacyanoferrate(ll) et de l'hexacyanoferrate(lll) par
spectrométrie





Reference number
ISO 7766:2003(E)
©
ISO 2003

---------------------- Page: 1 ----------------------
ISO 7766:2003(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


©  ISO 2003
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2003 — All rights reserved

---------------------- Page: 2 ----------------------
ISO 7766:2003(E)
Contents Page
Foreword. iv
Introduction . v
1 Scope. 1
2 Normative references . 1
3 Safety and operational precautions . 1
4 Principle . 2
5 Reactions . 3
6 Reagents and materials. 3
7 Apparatus. 4
8 Sampling and sample preparation . 4
9 Procedure. 5
10 Expression of results. 6
11 Test report. 6
Bibliography . 7

© ISO 2003 — All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 7766:2003(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
Int
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.