ISO 14132-3:2014

INTERNATIONAL ISO
STANDARD 14132-3
Second edition
2014-11-15
Optics and photonics — Vocabulary
for telescopic systems —
Part 3:
Terms for telescopic sights
Optique et photonique — Vocabulaire relatif aux systèmes
télescopiques —
Partie 3: Termes pour lunettes de pointage
Reference number
ISO 14132-3:2014(E)
©
ISO 2014

---------------------- Page: 1 ----------------------
ISO 14132-3:2014(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 14132-3:2014(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Terms and definitions . 1
Bibliography . 4
© ISO 2014 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 14132-3:2014(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity
assessment, as well as information about ISO’s adherence to the WTO principles in the Technical Barriers
to Trade (TBT) see the following URL: Foreword — Supplementary information.
The committee responsible for this document is ISO/TC 172, Optics and photonics, Subcommittee SC 4,
Telescopic systems.
This second edition cancels and replaces the first edition (ISO 14132-3:2002), which has been
technically revised.
ISO 14132 consists of the following parts, under the general title Optics and photonics — Vocabulary for
telescopic systems:
— Part 1: General terms and alphabetical indexes of terms in ISO 14132
— Part 2: Terms for binoculars, monoculars and spotting scopes
— Part 3: Terms for telescopic sights
— Part 4: Terms for astronomical telescopes
— Part 5: Terms for night vision devices
iv © ISO 2014 – All rights reserved

---------------------- Page: 4 ---------------
...