ISO 13105-2:2014
(Main)Building construction machinery and equipment — Machinery for concrete surface floating and finishing — Part 2: Safety requirements and verification
Building construction machinery and equipment — Machinery for concrete surface floating and finishing — Part 2: Safety requirements and verification
ISO 13105-2:2014 specifies safety requirements for machines used for concrete surface floating and finishing. This includes pedestrian-controlled equipment and ride-on equipment. It is not applicable to internal or external vibrators or ancillary equipment used with internal and external vibrators, for example, air compressors, hydraulic power sources, and voltage transformers, to remote-controlled or hand-held smoothing machines and self-acting (robotic) smoothing machines, or to strike-off type machines commonly known as screeds. It deals with significant hazards, hazardous situations, or hazardous events relevant to machinery for concrete surface floating and finishing (power trowels) when used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer. It is not applicable to machines which are manufactured before the date of its publication.
Machines et matériels pour la construction des bâtiments — Talocheuses-lisseuses de mortier — Partie 2: Les exigences de sécurité et de vérification
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 13105-2
First edition
2014-12-01
Building construction machinery and
equipment — Machinery for concrete
surface floating and finishing —
Part 2:
Safety requirements and verification
Machines et matériels pour la construction des bâtiments —
Talocheuses-lisseuses de mortier —
Partie 2: Les exigences de sécurité et de vérification
Reference number
ISO 13105-2:2014(E)
©
ISO 2014
---------------------- Page: 1 ----------------------
ISO 13105-2:2014(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 13105-2:2014(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Safety requirements and/or protective/risk reduction measures . 2
4.1 General requirements for all machines . 2
4.2 Safety requirements for pedestrian-controlled machines . 4
4.3 Safety requirements for ride-on machines . 5
5 Verification of safety requirements and/or protective/risk reduction measures .6
6 Information for use . 6
6.1 Operator’s manual. 6
6.2 Safety and instructional signs . 7
6.3 Marking . 7
Annex A (normative) Noise and vibration tests . 9
Annex B (informative) List of significant hazards.12
Bibliography .14
© ISO 2014 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 13105-2:2014(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.