EN ISO 10239:2017

SLOVENSKI STANDARD
01-oktober-2017
1DGRPHãþD
SIST EN ISO 10239:2015
0DODSORYLOD6LVWHPL]DXWHNRþLQMHQLQDIWQLSOLQ/3*,62
Small craft - Liquefied petroleum gas (LPG) systems (ISO 10239:2014)
Kleine Wasserfahrzeuge - Flüssiggas-Anlagen (LPG) (ISO 10239:2014)
Petits navires - Installations alimentées en gaz de pétrole liquéfiés (GPL) (ISO
10239:2014)
Ta slovenski standard je istoveten z: EN ISO 10239:2017
ICS:
47.080 ýROQL Small craft
75.160.30 Plinska goriva Gaseous fuels
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN ISO 10239
EUROPEAN STANDARD
NORME EUROPÉENNE
August 2017
EUROPÄISCHE NORM
ICS 47.080 Supersedes EN ISO 10239:2014
English Version
Small craft - Liquefied petroleum gas (LPG) systems (ISO
10239:2014)
Petits navires - Installations alimentées en gaz de Kleine Wasserfahrzeuge - Flüssiggas-Anlagen (LPG)
pétrole liquéfiés (GPL) (ISO 10239:2014) (ISO 10239:2014)
This European Standard was approved by CEN on 16 July 2017.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 10239:2017 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 2013/53/EU . 4
European foreword
The text of ISO 10239:2014 has been prepared by Technical Committee ISO/TC 188 “Small craft” of the
International Organization for Standardization (ISO) and has been taken over as EN ISO 10239:2017.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by February 2018, and conflicting national standards shall
be withdrawn at the latest by February 2018.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 10239:2014.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this
document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands,
Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
the United Kingdom.
Endorsement notice
The text of ISO 10239:2014 has been approved by CEN as EN ISO 10239:2017 without any modification.
Annex ZA
(informative)
Relationship between this European Standard and the Essential
Requirements of EU Directive 2013/53/EU
This European standard has been prepared under a mandate given to CEN by the European Commission
to provide one means of conforming to Essential Requirements of the New Approach Directive
2013/53/EU.
Once this standard is cited in the Official Journal of the European Union under that Directive and has been
implemented as a national standard in at least one member state, compliance with the normative clauses
of this standard given in Table ZA.1 confers, within the limits of the scope of this standard, a presumption
of conformity with the relevant Essential Requirements of that Directive and associated EFTA
regulations.
Table ZA.1 — Correspondence between this European Standard and Directive 2013/53/EU
Clauses/sub-clauses of Essential requirements (ERs) of Comments
this European Standard EU Directive 2013/53/EU
1, 2, 3, 4, 5, 6, 7, 8 ,9 ,10, 11, I.A.5.5 – Gas System This standard satisfies the legal
13, requirements of this essential
requirement in respect of Liquid
Annex A,
Petroleum Gas systems. Attention
Annex B,
shall be paid to the limitations set
Annex D
out in the scope in respect of its
application to propulsion engines,
generators and commissioning of
installations.
An appliance shall be used for the
application intended by the
manufacturer and installed in
accordance with the
manufacturer’s instructions in
accordance with clause 7.1; there
is no specific legal requirement for
appliances to be equipped with a
flame failure device effective on all
burners (clause 7.3) although they
may be provided by the
manufacturer.
Annex D applies in respect of
cooking appliances with integral
LPG cartridges with a capacity of
225 g or less.
The use of a pressure gauge in the
high pressure side of the system
will not detect cylinder valve ‘let
by’ or ’creep’ which, if suspected,
should be tested for separately.
Clause 6.5, 7.7, 7.9, 1.A.5.6.1 - Fire protection, general Annex D applies in respect of
cooking appliances with integral
Annex C,
LPG cartridges with a capacity of
Annex D
225 g or less.
Clause 12, 1.A.2.5 - Owner’s manual Annex D applies in respect of
cooking appliances with integral
Annex C,
LPG cartridges with a capacity of
Annex D.9
225 g or less.
WARNING: Other requirements and other EU Directives may be applicable to the product(s) falling
within the scope of this standard.

INTERNATIONAL ISO
STANDARD 10239
Third edition
2014-12-01
Small craft — Liquefied petroleum gas
(LPG) systems
Petits navires — Installations alimentées en gaz de pétrole
liquéfiés (GPL)
Reference number
ISO 10239:2014(E)
©
ISO 2014
ISO 10239:2014(E)
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved

ISO 10239:2014(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 General provisions. 3
5 Pressure regulation device . 4
6 LPG supply line . 5
6.1 General . 5
6.2 Piping . 5
6.3 Hoses and hose lines . 6
6.4 Materials . 6
6.5 Installation . 6
6.6 Shut-off valves . 7
7 Appliances . 8
8 Location and installation of LPG cylinders. 9
9 Ventilation . 9
10 LPG installation tightness tests .10
11 Ignition protection from electrical devices .10
12 Owner’s manual.10
13 Ducts and flues for air intake and combustion product discharge .10
Annex A (informative) Design guidelines for pressure drop due to pipe resistance .12
Annex B (normative) Ventilation.13
Annex C (normative) Instructions to be included with the owner’s manual .14
Annex D (normative) Cooking appliances with integral LPG cartridges with a capacity of
225 g or less .16
Bibliography .17
ISO 10239:2014(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison wi
...