Water supply - Specification for indirectly heated unvented (closed) storage water heaters

This European Standard specifies the constructional and performance requirements and methods of test for indirectly heated, unvented (closed) storage water heaters of up to 2 000 l volume suitable for connection to a water supply at a pressure between 0,05 MPa and 1,0 MPa (0,5 bar and 10 bar), and fitted with control and safety devices designed to prevent the temperature of the stored drinking water from reaching 95 °C.
Whilst storage water heaters intended primarily for direct heating are not covered by this standard, it does allow the provision of electric heating elements for auxiliary use.

Wasserversorgung - Bestimmung für mittelbar beheizte, unbelüftete (geschlossene) Speicher-Wassererwärmer

Diese Europäische Norm legt die Anforderungen an die Konstruktionstechnik und die Leistung und Prüf-verfahren für mittelbar (indirekte) beheizte, unbelüftete (geschlossene) Speicher-Wassererwärmer bis zu 2 000 l Volumen fest, die für den Anschluss an ein Wasserversorgungssystem bei einem Druck zwischen 0,05 MPa und 1,0 MPa (0,5 bar und 10 bar) geeignet und mit Regel- und Sicherheitseinrichtungen ausge-rüstet sind, die so ausgelegt sind, dass die Temperatur des gespeicherten Trinkwassers 95 °C nicht übersteigt.
Obwohl diese Norm keine Speicher-Wassererwärmer behandelt, die hauptsächlich für direkte Erwärmung vorgesehen sind, lässt sie die Bereitstellung von elektrischen Heizelementen zu Hilfszwecken zu.

Alimentation en eau - Prescriptions pour préparateurs d'eau chaude par accumulation à chauffage indirect non ouverts à l'air libre (fermés)

La présente Norme européenne définit les exigences de construction et de performance et les méthodes d'essai applicables aux préparateurs d’eau chaude par accumulation à chauffage indirect non ouverts à l’air libre (fermés) d'une capacité maximale de 2 000 l, adaptés pour être raccordés à un réseau d'alimentation en eau à une pression comprise entre 0,05 MPa et 1,0 MPa (0,5 bar et 10 bar), et équipés de dispositifs de réglage et de sécurité conçus pour empêcher que la température de l'eau potable stockée n’atteigne 95 °C.
Bien que la présente norme ne s'applique pas aux préparateurs d’eau chaude destinés avant tout au chauffage direct, elle permet la mise à disposition d'éléments de chauffe électrique à usage d’appoint.

Oskrba z vodo - Specifikacija za posredno ogrevane neprezračevane (zaprte) akumulacijske grelnike vode

Ta evropski standard določa konstrukcijske zahteve in zahteve glede zmogljivosti ter preskusne metode za posredno ogrevane neprezračevane (zaprte) akumulacijske grelnike vode za največjo prostornino 2000 l, ki so primerni za priključitev na vir oskrbe z vodo pri tlaku od 0,05 Mpa do 1,0 Mpa (0,5 in 10 bara) ter opremljeni z nadzornimi in varnostnimi napravami, ki preprečujejo, da bi temperatura pitne vode v grelniku dosegla 100 °C.
Ta standard ne zajema grelnikov vode, ki so namenjeni predvsem za neposredno ogrevanje, vendar dovoljuje uporabo dodatnih električnih grelnih elementov.

General Information

Status
Withdrawn
Publication Date
14-Jun-2016
Withdrawal Date
04-Feb-2020
Current Stage
9960 - Withdrawal effective - Withdrawal
Completion Date
05-Feb-2020

Relations

Buy Standard

Standard
EN 12897:2016
English language
32 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)


2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Wasserversorgung - Bestimmung für mittelbar beheizte, unbelüftete (geschlossene) Speicher-WassererwärmerAlimentation en eau - Prescriptions pour réservoirs de stockage d'eau chaude à chauffage indirect sans mise à l'air libre (fermés)Water supply - Specification for indirectly heated unvented (closed) storage water heaters91.140.65Oprema za ogrevanje vodeWater heating equipmentICS:Ta slovenski standard je istoveten z:EN 12897:2016SIST EN 12897:2016en,fr,de01-september-2016SIST EN 12897:2016SLOVENSKI
STANDARDSIST EN 12897:20061DGRPHãþD

EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12897
June
t r s x ICS
{ sä s v rä x w Supersedes EN
s t z { yã t r r xEnglish Version
Water supply æ Specification for indirectly heated Alimentation en eau æ Prescriptions pour préparateurs d 5eau chaude par accumulation à chauffage indirect
Wasserversorgung æ Bestimmung für mittelbar Wassererwärmer This European Standard was approved by CEN on
s w April
t r s xä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey and United Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
t r s x CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
s t z { yã t r s x ESIST EN 12897:2016

Hot water safety and performance testing . 17 A.1 Tests required . 17 A.2 Test apparatus and tolerances . 17 A.3 Performance tests . 19 A.4 Interpretation and calculation of hot water performance results . 21 A.5 Function of safety devices. 22 Annex B (normative)
Measurement of standing heat loss for factory insulated storage water heaters . 23 B.1 General . 23 B.2 Apparatus . 23 B.3 Test Procedure . 25 B.4 Calculation of Results . 26 Annex C (informative)
Inspection access . 28 Annex ZA (informative)
Relationship between this European Standard and the requirements of Commission Delegated Regulation (EU) No 812/2013 of 18 February 2013 supplementing Directive 2010/30/EU regarding energy labelling for water heaters and hot water storage tanks . 30 Annex ZB (informative)
Relationship between this European Standard and the requirements of Commission Regulation (EU) No 814/2013 of 2 August 2013 implementing Directive 2009/125/EC with regard to Ecodesign requirements for water heaters and hot water storage tanks . 31 Bibliography . 32
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.