ECISS/TC 1/SC 1 - Mechanical testing

ISO 6507-3:2005 specifies a method for the calibration of reference blocks to be used for the indirect verification of Vickers hardness testing machines, as specified in ISO 6507-2.
The method is applicable only for indentations with diagonals greater than or equal to 0,020 mm.

ISO 6507-1:2005 specifies the Vickers hardness test method for the three different ranges of test force for metallic materials.
The Vickers hardness test is specified in ISO 6507-1:2005 for lengths of indentation diagonals between 0,020 mm and 1,400 mm.

ISO 6507-2:2005 specifies a method of verification of testing machines for determining Vickers hardness in accordance with ISO 6507-1.

This European Standard specifies the method for tensile testing of metallic materials and defines the mechanical properties which can be determined thereby at elevated temperature. For certain particular metallic materials and applications, the tensile test may be subject of specific standards or particular requirements.

This part of this European Standard describe the Charpy impact test (U and V notch) for metallic materials. For certain particular metallic materials and applications, the Charpy impact test may be the subject of specific standards and particular requirements.

This EN applies to the verification of (pendulum) impact testing machines used for the Charpy impact test as described in EN 10045/1. It describes two methods - The direct method allowing the physical and geometrical properties of the different parts of the testing machine to be verified stactically and seperately - The indirect method; global verification method of the pendulum impact testing machine using Charpy V reference test pieces as specifies in 6.2.

Method for the indentification of test pieces axes in relation to the grain flow, by means of a system of co-ordinates. It is applied only when a uniform grain flow can be unambigously indentified

This European Standard specifies a method for the static verification of extensometers used in uniaxial testing. The term "extensometer" is understood to mean the displacement measuring device and the system for indicating or recording this displacement.

This Draft European Standard specifies a method for the verification of testing machines used for determining Brinell hardness in accordance with EN 10003-1. It describes a direct verification method for checking the main functions of the machine, and an indirect verification method suitable for the overall checking of the machine. If a testing machine is also to be used for other methods of hardness testing, it shall be verified independently for each method.

This European standard specifies a method for the Rockwell superficial hardness test for metallic materials

This Draft European Standard specifies a method of verification of testing machines for determining Rockwell hardness (scales A,B,C,D,E,F,G,H,K,N,T) in accordance with EN 10109-1.  It describes a direct verification method for checking the main functions of the machine and an indirect verification method suitable for the overall checking of the machine.  The indirect verification method may be used on its own for periodic routine checking of the machine in in service.

This Draft European Standard speciifies the method for the Brinell hardness test for metallic materials.  Special European Standards exist for particular materials and/or (see clause 2).

This Draft European Standard specifies a method for the calibration of standardized blocks to be used in Brinell hardness testing machines, for the indirect verification of these machine, as described in accordance with EN 10003-2.

This Draft European Standard specifies a method for the calibration of standardized blocks to be used in Rockwell hardness testing machines (scales A, B,C,D,E,F,G,K,N,T) for the indirect verification of these machines, as described in EN 10109-2.  The normative annex A shows the uniformity requirements of the standardized blocks diagrammatically.

This European Standard specifies the verification of the force measuring system of tensile testing machines. This verification shall be preceded by a general inspection of the testing machine. The dynamic verification of the forces applied by tensile testing machines is excluded from this standard. This standard is not concerned with the verification of extensometers.