SIST EN 16211:2025

SLOVENSKI STANDARD
oSIST prEN 16211:2023
01-maj-2023
Nadomešča:
SIST EN 16211:2015
Prezračevanje stavb - Meritve pretoka zraka v sistemu prezračevanja - Metode
Ventilation for buildings - Measurement of air flow rates on site - Methods
Lüftung von Gebäuden - Luftvolumenstrommessung vor Ort - Verfahren
Ventilation des bâtiments - Mesurages des débits d'air sur site - Méthodes
Ta slovenski standard je istoveten z: prEN 16211
ICS:
91.140.30 Prezračevalni in klimatski Ventilation and air-
sistemi conditioning systems
oSIST prEN 16211:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

oSIST prEN 16211:2023
oSIST prEN 16211:2023
DRAFT
EUROPEAN STANDARD
prEN 16211
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2023
ICS 17.120.10; 91.140.30 Will supersede EN 16211:2015
English Version
Ventilation for buildings - Measurement of air flow rates
on site - Methods
Ventilation des bâtiments - Mesurages des débits d'air Lüftung von Gebäuden - Luftvolumenstrommessung
sur site - Méthodes vor Ort - Verfahren
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 156.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.

EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 16211:2023 E
worldwide for CEN national Members.

oSIST prEN 16211:2023
prEN 16211:2023 (E)
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Symbols and abbreviated terms . 8
5 Expression of air flow rate . 10
5.1 Hydraulic diameter . 10
5.2 Flow disturbances . 11
5.3 Stability of the flow rate . 11
5.4 Air density . 11
5.5 Conversion of dynamic pressure into air velocity . 12
5.6 Correction and conversion of measured air flow rate . 12
5.6.1 General . 12
5.6.2 Correction of the air flow rate . 13
5.6.3 Conversion of the air flow rate . 14
6 Measuring instruments requirements . 14
6.1 General . 14
6.2 Air flow rate measuring instruments . 15
6.3 Differential pressure measuring instruments. 15
6.4 Air velocity measuring instruments . 15
6.4.1 General . 15
6.4.2 Anemometers . 15
6.4.3 Pitot static tubes . 15
6.5 Temperature measuring instruments . 16
6.6 Atmospheric pressure measuring instruments . 16
7 Methods for measurement of air flow rates . 16
7.1 Overview of described methods . 16
7.2 Multi‐point measurement in the duct cross‐section – with measurement plane
criteria (ID1) . 17
7.2.1 Principle . 17
7.2.2 Apparatus . 18
7.2.3 Measurement procedure . 19
7.2.4 Expression of results . 23
7.3 Multipoint measurement in the duct cross‐section – without measurement plane
criteria (ID2) . 25
7.3.1 Principle . 25
7.3.2 Apparatus . 25
7.3.3 Measurement procedure . 26
7.3.4 Expression of results . 34
7.4 Fixed devices for air flow rate measurement (ID3, ST1 and ET1) . 38
7.4.1 Principle . 38
7.4.2 Apparatus . 39
7.4.3 Measurement procedure . 39
oSIST prEN 16211:2023
prEN 16211:2023 (E)
7.4.4 Expression of results . 39
7.5 Air flow rate measurement with tight bag at supply ATDs (ST2) . 40
7.5.1 Principle . 40
7.5.2 Apparatus . 41
7.5.3 Measurement procedure . 41
7.5.4 Expression of results . 42
7.6 Air flow rate measurement with flow hood (ST3 and ET2) . 42
7.6.1 Principle . 42
7.6.2 Apparatus . 43
7.6.3 Measurement procedure . 44
7.6.4 Expression of results . 46
Annex A (informative) Additional methods . 47
A.1 Tracer gas measurement (ID4) . 47
A.1.1 Principle . 47
A.1.2 Apparatus . 47
A.1.3 Measurement procedure – Conditions for homogeneous mixing of tracer gas . 48
A.1.4 Expression of result – Calculation of air flow rate . 49
A.2 Measurement using anemometer at air intake (IN1) or air exhaust (EX1) . 50
A.2.1 Principle . 50
A.2.2 Apparatus . 50
A.2.3 Measurement procedure . 50
A.2.4 Expression of results . 51
A.3 Point measurements using thermal anemometers on rectangular intake (IN2) and
exhaust (EX2) grilles on walls . 51
A.3.1 Principle . 51
A.3.2 Measurement instruments/Apparatus . 52
A.3.3 Measurement procedure . 52
A.3.4 Standard measurement uncertainty . 54
Annex B (informative) Measurement uncertainty . 56
B.1 Uncertainty of the result of a measurement . 56
B.2 Type B evaluation of standard uncertainty . 56
B.3 Combined standard uncertainty . 58
B.4 Expanded uncertainty .
...