ISO 19711-1:2018

INTERNATIONAL ISO
STANDARD 19711-1
First edition
2018-08
Building construction machinery and
equipment — Truck mixers —
Part 1:
Terminology and commercial
specifications
Machines et matériels pour la construction des bâtiments — Camions
malaxeurs —
Partie 1: Terminologie et spécifications commerciales
Reference number
ISO 19711-1:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 19711-1:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 19711-1:2018(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Commercial specifications . 5
4.1 Specifications and dimensions of truck mixers . 5
4.2 Specifications and dimensions of mixer device . 6
Annex A (informative) Examples of truck mixer structures and dimensions.7
Annex B (informative) Example of swivel chute with flip-over chute .11
Bibliography .12
© ISO 2018 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 19711-1:2018(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www .iso .org/patents).
Any trade name used in this document is
...