ISO 7176-25:2022/Amd 1:2025

International
Standard
ISO 7176-25
Second edition
Wheelchairs —
2022-10
Part 25:
AMENDMENT 1
Lead-acid batteries and chargers
2025-05
for powered wheelchairs —
Requirements and test methods
AMENDMENT 1: Range of charging
voltage and range of the minimum
and maximum rated DC output
voltage for testing
Fauteuils roulants —
Partie 25: Batteries au plomb et chargeurs pour fauteuils
roulants motorisés — Exigences et méthodes d’essai
AMENDEMENT 1: Plage de la tension de charge et plage de
la tension de sortie nominale minimale et maximale (courant
continu) pour les essais
Reference number
ISO 7176-25:2022/Amd.1:2025(en) © ISO 2025

ISO 7176-25:2022/Amd.1:2025(en)
© ISO 2025
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
ISO 7176-25:2022/Amd.1:2025(en)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee
has been established has the right to be represented on that committee. International organizations,
governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely
with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are described
in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types
of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the
ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation
...