EN ISO 1401:1999

SLOVENSKI STANDARD
01-december-2000
Gumene cevi za škropljenje v poljedelstvu (ISO 1401:1999)
Rubber hoses for agricultural spraying (ISO 1401:1999)
Gummischläuche zum Sprühen in der Landwirtschaft (ISO 1401:1999)
Tuyaux en caoutchouc pour pulvérisation agricole (ISO 1401: 1999)
Ta slovenski standard je istoveten z: EN ISO 1401:1999
ICS:
23.040.70 Gumene cevi in armature Hoses and hose assemblies
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

INTERNATIONAL ISO
STANDARD 1401
Third edition
1999-12-01
Rubber hoses for agricultural spraying
Tuyaux en caoutchouc pour pulvérisation agricole
A
Reference number
ISO 1401:1999(E)
ISO 1401:1999(E)
Contents Page
1 Scope .1
2 Normative references .1
3 Classification.1
4 Construction and materials .2
5 Dimensions and tolerances .2
5.1 Nominal bore and internal diameter .2
5.2 Length.2
5.3 Minimum thickness of lining and cover .2
6 Physical requirements on samples taken from the hose or from moulded sheets of equivalent
vulcanization .3
6.1 Tensile strength and elongation at break of rubber lining and cover.3
6.2 Requirements after immersion in fluid.3
6.3 Accelerated ageing.3
7 Physical requirements on finished hoses.3
7.1 Change in dimensions .3
7.2 Hydrostatic requirements .3
7.3 Bending-test requirements .4
7.4 Adhesion.4
7.5 Resistance to ozone .4
8 Marking .4
©  ISO 1999
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from the publisher.
International Organization for Standardization
Case postale 56 • CH-1211 Genève 20 • Switzerland
Internet iso@iso.ch
Printed in Switzerland
ii
©
ISO ISO 1401:1999(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
International Standard ISO 1401 was prepared by Technical Committee ISO/TC 45, Rubber and rubber products,
Subcommittee SC 1, Hoses (rubber and plastics).
This third edition cancels and replaces the second edition (ISO 1401:1987), which has been technically revised.
iii
©
INTERNATIONAL STANDARD  ISO ISO 1401:1999(E)
Rubber hoses for agricultural spraying
1 Scope
This International Standard specifies requirements for three types of flexible rubber hose for
...