ASTM D6839-13
(Test Method)Standard Test Method for Hydrocarbon Types, Oxygenated Compounds, and Benzene in Spark Ignition Engine Fuels by Gas Chromatography
Standard Test Method for Hydrocarbon Types, Oxygenated Compounds, and Benzene in Spark Ignition Engine Fuels by Gas Chromatography
SIGNIFICANCE AND USE
5.1 A knowledge of spark-ignition engine fuel composition is useful for regulatory compliance, process control, and quality assurance.
5.2 The quantitative determination of olefins and other hydrocarbon types in spark-ignition engine fuels is required to comply with government regulations.
5.3 This test method is not applicable to M85 fuels, which contain 85 % methanol.
SCOPE
1.1 This test method covers the quantitative determination of saturates, olefins, aromatics, and oxygenates in spark-ignition engine fuels by multidimensional gas chromatography. Each hydrocarbon type can be reported either by carbon number (see Note 1) or as a total.Note 1—There can be an overlap between the C9 and C10 aromatics; however, the total is accurate. Isopropyl benzene is resolved from the C8 aromatics and is included with the other C9 aromatics.
1.2 This test method is not intended to determine individual hydrocarbon components except benzene.
1.3 This test method is divided into two parts, Part A and Part B.
1.3.1 Part A is applicable to automotive motor gasoline for which precision (Table 9) has been obtained for total volume fraction of aromatics of up to 50 %; a total volume fraction of olefins from about 1.5 % up to 30 %; a volume fraction of oxygenates, from 0.8 % up to 15 %; a total mass fraction of oxygen from about 1.5 % to about 3.7 %; and a volume fraction of benzene of up to 2 %. Although this test method can be used to determine higher-olefin contents of up to 50 % volume fraction, the precision for olefins was tested only in the range from about 1.5 % volume fraction to about 30 % volume fraction. The method has also been tested for an ether content up to 22% volume fraction but no precision data has been determined.
1.3.1.1 This test method is specifically developed for the analysis of automotive motor gasoline that contains oxygenates, but it also applies to other hydrocarbon streams having similar boiling ranges, such as naphthas and reformates.
1.3.2 Part B describes the procedure for the analysis of oxygenated groups (ethanol, methanol, ethers, C3 to C5 alcohols) in ethanol fuels containing an ethanol volume fraction between 50 % and 85 % (17 to 29 % oxygen). The gasoline is diluted with an oxygenate-free component to lower the ethanol content to a value below 20 % before the analysis by GC. The diluting solvent should not be considered in the integration, this makes it possible to report the results of the undiluted sample after normalization to 100 %
1.4 Oxygenates as specified in Test Method D4815 have been verified not to interfere with hydrocarbons. Within the round robin sample set, the following oxygenates have been tested: MTBE, ethanol, ETBE, TAME, iso-propanol, isobutanol, tert-butanol and methanol. The derived precision data for methanol do not comply with the precision calculation as presented in this International Standard. Applicability of this test method has also been verified for the determination of n-propanol, acetone, and di-isopropyl ether (DIPE). However, no precision data have been determined for these compounds.
1.4.1 Other oxygenates can be determined and quantified using Test Method D4815 or D5599.
1.5 The method is harmonized with ISO 22854.
1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
General Information
Relations
Buy Standard
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: D6839 − 13
StandardTest Method for
Hydrocarbon Types, Oxygenated Compounds, and Benzene
1
in Spark Ignition Engine Fuels by Gas Chromatography
This standard is issued under the fixed designation D6839; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope diluting solvent should not be considered in the integration,
this makes it possible to report the results of the undiluted
1.1 This test method covers the quantitative determination
sample after normalization to 100 %
of saturates, olefins, aromatics, and oxygenates in spark-
ignitionenginefuelsbymultidimensionalgaschromatography.
1.4 Oxygenates as specified in Test Method D4815 have
Each hydrocarbon type can be reported either by carbon
been verified not to interfere with hydrocarbons. Within the
number (see Note 1) or as a total.
round robin sample set, the following oxygenates have been
NOTE 1—There can be an overlap between the C and C aromatics;
9 10 tested: MTBE, ethanol, ETBE, TAME, iso-propanol,
however, the total is accurate. Isopropyl benzene is resolved from the C
8
isobutanol, tert-butanol and methanol. The derived precision
aromatics and is included with the other C aromatics.
9
data for methanol do not comply with the precision calculation
1.2 This test method is not intended to determine individual
aspresentedinthisInternationalStandard.Applicabilityofthis
hydrocarbon components except benzene.
test method has also been verified for the determination of
n-propanol, acetone, and di-isopropyl ether (DIPE). However,
1.3 This test method is divided into two parts, Part A and
no precision data have been determined for these compounds.
Part B.
1.3.1 Part A is applicable to automotive motor gasoline for 1.4.1 Other oxygenates can be determined and quantified
which precision (Table 9) has been obtained for total volume using Test Method D4815 or D5599.
fraction of aromatics of up to 50 %; a total volume fraction of
1.5 The method is harmonized with ISO 22854.
olefins from about 1.5 % up to 30 %; a volume fraction of
1.6 The values stated in SI units are to be regarded as
oxygenates, from 0.8 % up to 15 %; a total mass fraction of
standard. No other units of measurement are included in this
oxygenfromabout1.5%toabout3.7%;andavolumefraction
standard.
of benzene of up to 2 %.Although this test method can be used
to determine higher-olefin contents of up to 50 % volume
1.7 This standard does not purport to address all of the
fraction, the precision for olefins was tested only in the range
safety concerns, if any, associated with its use. It is the
from about 1.5 % volume fraction to about 30 % volume
responsibility of the user of this standard to establish appro-
fraction. The method has also been tested for an ether content
priate safety and health practices and determine the applica-
up to 22% volume fraction but no precision data has been
bility of regulatory limitations prior to use.
determined.
1.3.1.1 This test method is specifically developed for the
2. Referenced Documents
analysis of automotive motor gasoline that contains
2
2.1 ASTM Standards:
oxygenates, but it also applies to other hydrocarbon streams
D4307 Practice for Preparation of Liquid Blends for Use as
havingsimilarboilingranges,suchasnaphthasandreformates.
Analytical Standards
1.3.2 Part B describes the procedure for the analysis of
D4815 Test Method for Determination of MTBE, ETBE,
oxygenated groups (ethanol, methanol, ethers, C to C alco-
3 5
TAME, DIPE, tertiary-Amyl Alcohol and C to C Alco-
1 4
hols) in ethanol fuels containing an ethanol volume fraction
hols in Gasoline by Gas Chromatography
between 50 % and 85 % (17 to 29 % oxygen). The gasoline is
D5599 Test Method for Determination of Oxygenates in
diluted with an oxygenate-free component to lower the ethanol
Gasoline by Gas Chromatography and Oxygen Selective
content to a value below 20 % before the analysis by GC. The
Flame Ionization Detection
1
This test method is under the jurisdiction of ASTM Committee D02 on
Petroleum Products, Liquid Fuels, and Lubricants and is the direct responsibility of
2
Subcommittee D02.04.0L on Gas Chromatography Methods. For referenced ASTM standards, visit the ASTM website, www.astm.org, or
Current edition approved Oct. 1, 2013. Published November 2013. Originally contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
approved in 2002. Last previous edition approved in 2007 as D6839 – 02 (2007). Standards volume information, refer to the standard’s Document Summary page on
DOI: 10.1520/D6839-13. the ASTM website.
Copyright © ASTM International, 100 Barr Ha
...
This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
Designation: D6839 − 02 (Reapproved 2007) D6839 − 13
Standard Test Method for
Hydrocarbon Types, Oxygenated Compounds, and Benzene
1
in Spark Ignition Engine Fuels by Gas Chromatography
This standard is issued under the fixed designation D6839; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 This test method covers the quantitative determination of saturates, olefins, aromatics, and oxygenates in spark-ignition
engine fuels by multidimensional gas chromatography. Each hydrocarbon type can be reported either by carbon number (see Note
1) or as a total.
NOTE 1—There can be an overlap between the C and C aromatics; however, the total is accurate. Isopropyl benzene is resolved from the C aromatics
9 10 8
and is included with the other C aromatics.
9
1.2 This test method is not intended to determine individual hydrocarbon components except benzene.
1.3 This test method is applicable to spark-ignition engine fuel with total aromatic content up to 50 % (V/V), total olefinic
content up to 30 % (V/V) and oxygen compounds up to 15 % (V/V).divided into two parts, Part A and Part B.
1.3.1 Part A is applicable to automotive motor gasoline for which precision (Table 9) has been obtained for total volume fraction
of aromatics of up to 50 %; a total volume fraction of olefins from about 1.5 % up to 30 %; a volume fraction of oxygenates, from
0.8 % up to 15 %; a total mass fraction of oxygen from about 1.5 % to about 3.7 %; and a volume fraction of benzene of up to
2 %. Although this test method can be used to determine higher-olefin contents of up to 50 % volume fraction, the precision for
olefins was tested only in the range from about 1.5 % volume fraction to about 30 % volume fraction. The method has also been
tested for an ether content up to 22% volume fraction but no precision data has been determined.
1.3.1.1 This test method is specifically developed for the analysis of automotive motor gasoline that contains oxygenates, but
it also applies to other hydrocarbon streams having similar boiling ranges, such as naphthas and reformates.
1.3.2 Part B describes the procedure for the analysis of oxygenated groups (ethanol, methanol, ethers, C to C alcohols) in
3 5
ethanol fuels containing an ethanol volume fraction between 50 % and 85 % (17 to 29 % oxygen). The gasoline is diluted with
an oxygenate-free component to lower the ethanol content to a value below 20 % before the analysis by GC. The diluting solvent
should not be considered in the integration, this makes it possible to report the results of the undiluted sample after normalization
to 100 %
1.3 This test method is not intended to determine individual hydrocarbon components except benzene.
1.4 Oxygenates as specified in Test Method D4815 have been verified not to interfere with hydrocarbons. Within the round robin
sample set, the following oxygenates have been tested: MTBE, ethanol, ETBE, TAME, iso-propanol, isobutanol, tertand TAME.
Other oxygenates can be determined -butanol and methanol. The derived precision data for methanol do not comply with the
precision calculation as presented in this International Standard. Applicability of this test method has also been verified for the
determination of n-propanol, acetone, and quantifieddi using Test Method-isopropyl ether (DIPE). However, D4815 orno precision
D5599.data have been determined for these compounds.
1.4.1 Other oxygenates can be determined and quantified using Test Method D4815 or D5599.
1.5 The method is harmonized with ISO 22854.
1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory
limitations prior to use.
1
This test method is under the jurisdiction of ASTM Committee D02 on Petroleum Products Products, Liquid Fuels, and Lubricants and is the direct responsibility of
Subcommittee D02.04.0L on Gas Chromatography Methods.
Current edition approved Nov. 1, 2007Oct. 1, 2013. Published January 2008November 2013. Originally approved in 2002. Last previous edition approved in 20022007
as D6839D6839
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.