SIST EN IEC 61837-2:2018/A1:2021

SLOVENSKI STANDARD
SIST EN IEC 61837-2:2018/A1:2021
01-januar-2021
Površinsko nameščeni piezoelektrični elementi za krmiljenje in izbiranje
(filtriranje) frekvenc - Standardne mere in priključni kontakti - 2. del: Keramični
okrovi - Dopolnilo A1 (IEC 61837-2:2018/A1:2020)
Surface mounted piezoelectric devices for frequency control and selection - Standard
outlines and terminal lead connections - Part 2: Ceramic enclosures (IEC 61837-
2:2018/A1:2020)
Oberflächenmontierbare piezoelektrische Bauteile zur Frequenzstabilisierung und -
selektion - Norm-Gehäusemaße und Anschlüsse - Teil 2: Keramikgehäuse (IEC 61837-
2:2018/A1:2020)
Dispositifs piézoélectriques à montage en surface pour la commande et le choix de la
fréquence - Encombrements normalisés et connexions des sorties - Partie 2:
Enveloppes en céramique (IEC 61837-2:2018/A1:2020)
Ta slovenski standard je istoveten z: EN IEC 61837-2:2018/A1:2020
ICS:
31.140 Piezoelektrične naprave Piezoelectric devices
SIST EN IEC 61837-2:2018/A1:2021 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN IEC 61837-2:2018/A1:2021

---------------------- Page: 2 ----------------------
SIST EN IEC 61837-2:2018/A1:2021


EUROPEAN STANDARD EN IEC 61837-2:2018/A1

NORME EUROPÉENNE

EUROPÄISCHE NORM
November 2020
ICS 31.140

English Version
Surface mounted piezoelectric devices for frequency control and
selection - Standard outlines and terminal lead connections -
Part 2: Ceramic enclosures
(IEC 61837-2:2018/A1:2020)
Dispositifs piézoélectriques à montage en surface pour la Oberflächenmontierbare piezoelektrische Bauteile zur
commande et le choix de la fréquence - Encombrements Frequenzstabilisierung und -selektion - Norm-
normalisés et connexions des sorties - Partie 2: Enveloppes Gehäusemaße und Anschlüsse - Teil 2: Keramikgehäuse
en céramique (IEC 61837-2:2018/A1:2020)
(IEC 61837-2:2018/A1:2020)
This amendment A1 modifies the European Standard EN IEC 61837-2:2018; it was approved by CENELEC on 2020-10-29. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.


European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN IEC 61837-2:2018/A1:2020 E

---------------------- Page: 3 ----------------------
SIST EN IEC 61837-2:2018/A1:2021
EN IEC 61837-2:2018/A1:2020 (E)
European foreword
The text of document 49/1338/CDV, future IEC 61837-2/A1, prepared by IEC/TC 49 "Piezoelectric,
dielectric and electrostatic devices and associated materials for frequency control, selection and
detection" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as
EN IEC 61837-2:2018/A1:2020.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2021-07-29
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2023-10-29
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice
The text of the International Standard IEC 61837-2:2018/A1:2020 was approved by CENELEC as a
European Standard without any modification.

2

---------------------- Page: 4 ----------------------
SIST EN IEC 61837-2:2018/A1:2021



IEC 61837-2

®


Edition 3.0 2020-09




INTERNATIONAL



STANDARD














AMENDMENT 1





Surface mounted piezoelectric devices for frequency control and selection –

Standard outlines and terminal lead connections –

Part 2: Ceramic enclosures

























INTERNATIONAL

ELECTROTECHNICAL

COMMISSION






ICS 31.140 ISBN 978-2-8322-8838-2




  Warning! Make sure that you obtained this publication from an authorized distributor.


® Registered trademark of the International Electrotechnical Commission

---------------------- Page: 5 ----------------------
SIST EN IEC 61837-2:2018/A1:2021
– 2 – IEC 61837-2:2018/AMD1:2020
 © IEC 2020
FOREWORD
This amendment has been prepared by IEC technical committee 49: Piezoelectric, dielectric
and electrostatic devices and associated materials for frequency control, selection and
detection.
The text of this amendment is based on the following documents:
FDIS Report on voting
49/1338/CDV 49/1347/RVC

Full information on the voting for the approval of this amendment can be found in the report
on voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC website under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
_____________

8 Designation of ceramic enclosures
Replace Table 1 with the following:

---------------------- Page: 6 ----------------------
SIST EN IEC 61837-2:2018/A1:2021
IEC 61837-2:2018/AMD1:2020 – 3 –
© IEC 2020
Table 1 – Designation of ceramic enclosures
No. Type Old type Sheet No. Description
1 QCC-18/1809A QCC-18/01 Sheet 1 Ceramic, welded, eighteen leadless SMD outline
2 QCC-12/1407A Sheet 2 Ceramic, welded, twelve leadless SMD outline
3 DCC-4/1206A DCC-4/01 Sheet 3 Ceramic, four leadless SMD outline
4 DCC-2/1206A Sheet 4 Ceramic, two leadless SMD outline
5 QCC-10/9272A Sheet 5 Ceramic, welded, ten leadless SMD outline
6 DCC-4/9070A Sheet 6 Ceramic, welded, four leadless SMD outline
7 DCC-4/8045B DCC-04/02, 03 Sheet 7 Ceramic, welded, four leadless SMD outline
8 DCC-2/8045B Sheet 8 Ceramic, welded, two leadless SMD outline
9 DCC-6/7834B Sheet 9 Ceramic, welded, six leadless SMD outline
10 DCC-6/7050A Sheet 10 Ceramic, welded, six leadless SMD outline
11 DCC-4/7050A DCC-4/08 Sheet 11 Ceramic, welded, four leadless SMD outline
12 DCC-4/7050B DCC-4/04, 05 Sheet 12 Ceramic, welded, four leadless SMD outline
13 QCC-10/7050A Sheet 13 Ceramic, welded, ten leadless SMD outline
14 QCC-6/7050A QCC-6/01, 02 Sheet 14 Ceramic, welded, six leadless SMD outline
15 DCC-6/6035A DCC-4/06, 07 Sheet 15 Ceramic, welded, six leadless SMD outline
16 DCC-4/6035C Sheet 16 Ceramic, welded, four leadless SMD outline
17 DCC-2/6035C Sheet 17 Ceramic, welded, two leadless SMD outline
18 QCC-8/5050A QCC-8/02 Sheet 18 Ceramic, welded, eight leadless SMD outline
19 QCC-12/5045A QCC-12/02 Sheet 19 Ceramic, welded, twelve leadless SMD outline
20 QCC-8/5045A Sheet 20 Ceramic, welded, eight leadless SMD outline
21 DCC-6/5032A Sheet 21 Ceramic, welded, six leadless SMD outline
22 DCC-4/5032A Sheet 22 Ceramic, welded, four leadless SMD outline
23 DCC-4/5032C Sheet 23 Ceramic, welded, four leadless SMD outline
24 DCC-2/5032B DCC-2/01 Sheet 24 Ceramic, welded, two leadless SMD outline
25 DCC-2/4818C Sheet 25 Ceramic, welded, two leadless SMD outline
26 DCC-2/4115C Sheet 26 Ceramic, welded, two leadless SMD outline
27 DCC-4/4025C DCC-6/01 Sheet 27 Ceramic, welded, four leadless SMD outline
28 QCC-8/3838A Sheet 28 Ceramic, welded, eight leadless SMD outline
29 DCC-6/3838A Sheet 29 Ceramic, welded, six leadless SMD outline
30 DCC-6/3225A Sheet 30 Ceramic, welded, six leadless SMD outline
31 DCC-4/3225C Sheet 31 Ceramic, welded, four leadless SMD outline
32 DCC-4/3215C Sheet 32 Ceramic, welded, four leadless SMD outline
33 DCC-2/3215C Sheet 33 Ceramic, welded, two leadless SMD outline
34 QCC-8/3030B Sheet 34 Ceramic, welded, eight leadless SMD outline
...