SIST EN 60062:2016/AC:2017

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.&25Kennzeichnung von Widerständen und KondensatorenCodes de marquage des résistances et des condensateursMarking codes for resistors and capacitors (IEC 60062:2016/COR1:2016)31.060.01Kondenzatorji na splošnoCapacitors in general31.040.01Upori splošnoResistors in generalICS:Ta slovenski standard je istoveten z:EN 60062:2016/AC:2016-12SIST EN 60062:2016/AC:2017en01-februar-2017SIST EN 60062:2016/AC:2017SLOVENSKI
STANDARD



SIST EN 60062:2016/AC:2017



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM EN 60062:2016/AC:2016-12
December 2016
ICS 31.020 English Version
Marking codes for resistors and capacitors (IEC 60062:2016/COR1:2016)
Codes de marquage des résistances et des condensateurs(IEC 60062:2016/COR1:2016)
Kennzeichnung von Widerständen und Kondensatoren (IEC 60062:2016/COR1:2016) This corrigendum becomes effective on 16 December 2016 for incorporation in the English language version of the EN. European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique Europäisches Komitee für Elektrotechnische Normung CEN-CENELEC Management Centre: Avenue Marnix 17,
B-1000 Brussels © 2016 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 60062:2016/AC:2016-12 ESIST EN 60062:2016/AC:2017



EN 60062:2016/AC:2016-12
Endorsement notice
The text of the corrigendum IEC 60062:2016/COR1:2016
was approved by CENELEC as EN 60062:2016/AC:2016-12 without any modification.
SIST EN 60062:2016/AC:2017



IEC 60062:2016/COR1:2016 – 1 –
 IEC 2016 INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ÉLECTROTECHNIQUE INTERNATIONALE ____________
IEC 60062 Edition 6.0
2016-07
MARKING CODES FOR RESISTORS AND CAPACITORS IEC 60062 Édition 6.0
2016-07
MARQUAGE DES CODES POUR RESISTANCES ET CONDENSATEURS
CORRIGENDUM 1
CONTENTS Replace the entry for Annex B by the following entry: Annex X (informative) Cross-reference for references to the previous edition of this standard Replace the entry for Table B.1 by the following entry: Table X.1 – Cross-reference to Clauses
Replace the entry for Table B.2 by the following entry: Table X.2 – Cross-reference to Tables 3.1 General rules Replace the 2nd paragraph by the following text: Wherever possible, the first band shall be the one nearest to the end of the resistor and the bands shall be so placed and spaced that there can be no confusion in reading the coding. Replace the 3rd paragraph by the following text and note: The design width of the band used for SOMMAIRE Remplacer l'entrée pour l'Annexe B par l'entrée suivante: Annexe X (informative) Correspondance des références par rapport à l'édition précédente de la présente norme Remplacer l'en
...