ISO 13826:2013
(Main)Metallic and other inorganic coatings — Determination of thermal diffusivity of thermally sprayed ceramic coatings by laser flash method
Metallic and other inorganic coatings — Determination of thermal diffusivity of thermally sprayed ceramic coatings by laser flash method
ISO 13826:2013 specifies a test method of thermal diffusivity of thermally sprayed ceramic coatings using laser technology. This test method is applicable to self-standing thermally sprayed ceramic coatings of thickness between 0,8 mm to 2 mm, deposited by various thermal spray processes and removed from the substrate. Thermal diffusivity values ranging from 10−7 m2/s to 10−4 m2/s are measurable by this test method for temperature range from 300 K to 1500 K.
Revêtements métalliques et autres revêtements inorganiques — Détermination de la diffusivité thermique des revêtements céramiques obtenus par projection thermique par la méthode flash laser
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 13826
First edition
2013-01-15
Metallic and other inorganic
coatings — Determination of thermal
diffusivity of thermally sprayed
ceramic coatings by laser flash method
Revêtements métalliques et autres revêtements inorganiques —
Détermination de la diffusivité thermique des revêtements céramiques
obtenus par projection thermique par la méthode flash laser
Reference number
ISO 13826:2013(E)
©
ISO 2013
---------------------- Page: 1 ----------------------
ISO 13826:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 13826:2013(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Terms and definitions . 1
3 Principle of test method . 1
4 Test method . 2
4.1 General . 2
4.2 Apparatus . 2
5 Test specimen (disc) . 3
6 Procedures . 3
7 Calculation of thermal diffusivity . 4
8 Test report . 4
Annex A (informative) Calculations of thermal diffusivity after appropriate corrections .6
Bibliography .11
© ISO 2013 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 13826:2013(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
International Standards are drafted in accordance with the rules g
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.