ISO/TS 7849-1:2009
(Main)Acoustics — Determination of airborne sound power levels emitted by machinery using vibration measurement — Part 1: Survey method using a fixed radiation factor
Acoustics — Determination of airborne sound power levels emitted by machinery using vibration measurement — Part 1: Survey method using a fixed radiation factor
ISO/TS 7849-1:2009 gives basic requirements for reproducible methods for the determination of an upper limit for the A-weighted sound power level of the noise emitted by machinery or equipment by using surface vibration measurements. The method is only applicable to noise which is emitted by vibrating surfaces of solid structures and not to noise generated aerodynamically. This vibration measurement method is especially applicable in cases where accurate direct airborne noise measurements, e.g. as specified in ISO 3746, ISO 3747, and ISO 9614 (all parts), are not possible because of high background noise or other parasitic environmental interferences; or if a distinction is required between the total radiated sound power and its structure vibration generated component. The methods described in ISO/TS 7849-1:2009 apply mainly to processes that are stationary with respect to time.
Acoustique — Détermination des niveaux de puissance acoustique aériens émis par les machines par mesurage des vibrations — Partie 1: Méthode de contrôle employant un facteur de rayonnement fixe
Akustika - Določanje ravni zvočnih moči v zraku, ki jih povzročajo stroji, z merjenjem vibracij - 1. del: Informativna metoda z uporabo konstantnega faktorja sevanja
General Information
Relations
Buy Standard
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TS ISO/TS 7849-1:2014
01-februar-2014
1DGRPHãþD
SIST ISO/TR 7849:1997
$NXVWLND'RORþDQMHUDYQL]YRþQLKPRþLY]UDNXNLMLKSRY]URþDMRVWURML]
PHUMHQMHPYLEUDFLMGHO,QIRUPDWLYQDPHWRGD]XSRUDERNRQVWDQWQHJDIDNWRUMD
VHYDQMD
Acoustics -- Determination of airborne sound power levels emitted by machinery using
vibration measurement -- Part 1: Survey method using a fixed radiation factor
Acoustique -- Détermination des niveaux de puissance acoustique aériens émis par les
machines par mesurage des vibrations -- Partie 1: Méthode de contrôle employant un
facteur de rayonnement fixe
Ta slovenski standard je istoveten z: ISO/TS 7849-1:2009
ICS:
17.140.20 Emisija hrupa naprav in Noise emitted by machines
opreme and equipment
17.160 Vibracije, meritve udarcev in Vibrations, shock and
vibracij vibration measurements
SIST-TS ISO/TS 7849-1:2014 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS ISO/TS 7849-1:2014
---------------------- Page: 2 ----------------------
SIST-TS ISO/TS 7849-1:2014
TECHNICAL ISO/TS
SPECIFICATION 7849-1
First edition
2009-03-15
Acoustics — Determination of airborne
sound power levels emitted by machinery
using vibration measurement —
Part 1:
Survey method using a fixed radiation
factor
Acoustique — Détermination des niveaux de puissance acoustique
aériens émis par les machines par mesurage des vibrations —
Partie 1: Méthode de contrôle employant un facteur de rayonnement
fixe
Reference number
ISO/TS 7849-1:2009(E)
©
ISO 2009
---------------------- Page: 3 ----------------------
SIST-TS ISO/TS 7849-1:2014
ISO/TS 7849-1:2009(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2009
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2009 – All rights reserved
---------------------- Page: 4 ----------------------
SIST-TS ISO/TS 7849-1:2014
ISO/TS 7849-1:2009(E)
Contents Page
Foreword. iv
Introduction . v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions. 2
4 Principle. 4
5 Measuring instrumentation. 5
5.1 General. 5
5.2 Vibration transducer. 5
5.3 Non-contacting transducers. 5
5.4 Amplifier .
...
TECHNICAL ISO/TS
SPECIFICATION 7849-1
First edition
2009-03-15
Acoustics — Determination of airborne
sound power levels emitted by machinery
using vibration measurement —
Part 1:
Survey method using a fixed radiation
factor
Acoustique — Détermination des niveaux de puissance acoustique
aériens émis par les machines par mesurage des vibrations —
Partie 1: Méthode de contrôle employant un facteur de rayonnement
fixe
Reference number
ISO/TS 7849-1:2009(E)
©
ISO 2009
---------------------- Page: 1 ----------------------
ISO/TS 7849-1:2009(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2009
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2009 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/TS 7849-1:2009(E)
Contents Page
Foreword. iv
Introduction . v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions. 2
4 Principle. 4
5 Measuring instrumentation. 5
5.1 General. 5
5.2 Vibration transducer. 5
5.3 Non-contacting transducers. 5
5.4 Amplifier . 6
5.5 Integrator . 6
5.6 Calibration . 6
6 Installation and operation of source under test . 6
6.1 General. 6
6.2 Description of the machine. 7
6.3 Installation . 7
6.4 Operating conditions. 7
7 Determination of the vi
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.