ISO 1004-2:2013
(Main)Information processing — Magnetic ink character recognition — Part 2: Print specifications for CMC7
Information processing — Magnetic ink character recognition — Part 2: Print specifications for CMC7
ISO 1004-2:2013 specifies the shapes, dimensions and tolerances for the 10 digits 0 to 9, five symbols, and 26 letters, to be printed with magnetic ink for the purpose of character recognition. It describes the various types of printing defects and other printing considerations, together with the tolerances permitted, and also contains specifications to signal level measurement.
Traitement de l'information — Reconnaissance des caractères à encre magnétique — Partie 2: Spécifications d'impression CMC7
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 1004-2
First edition
2013-06-01
Information processing — Magnetic
ink character recognition —
Part 2:
Print specifications for CMC7
Traitement de l’information — Reconnaissance des caractères à
encre magnétique —
Partie 2: Spécifications d’impression CMC7
Reference number
ISO 1004-2:2013(E)
©
ISO 2013
---------------------- Page: 1 ----------------------
ISO 1004-2:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 1004-2:2013(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms, definitions, symbols and abbreviations . 1
3.1 Terms and definitions . 1
3.2 Symbols and abbreviations . 2
4 Character configuration . 3
4.1 Code description . 3
4.2 Configuration . 3
5 Means of automatic sensing . 4
6 Reference edges of documents . 4
7 Print location. 4
7.1 Horizontal location . 4
7.2 Vertical location. 4
8 Clear band . 4
9 Character spacing and alignment . 5
9.1 Horizontal character spacing. 5
9.2 Vertical misalignment . 5
10 Character definition and tolerances .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.