ISO 1004-1:2013
(Main)Information processing — Magnetic ink character recognition — Part 1: Print specifications for E13B
Information processing — Magnetic ink character recognition — Part 1: Print specifications for E13B
ISO 1004-1:2013 specifies the shape, dimensions, magnetic signal level, and tolerances for the E-13B characters which include 10 numerals and four special symbols printed in magnetic ink and used for the purpose of character recognition. It describes the various known types of printing defects and other printing considerations, together with the tolerances permitted.
Traitement de l'information — Reconnaissance des caractères à encre magnétique — Partie 1: Spécifications d'impression E13B
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 1004-1
First edition
2013-06-01
Information processing — Magnetic
ink character recognition —
Part 1:
Print specifications for E13B
Traitement de l’information — Reconnaissance des caractères à
encre magnétique —
Partie 1: Spécifications d’impression E13B
Reference number
ISO 1004-1:2013(E)
©
ISO 2013
---------------------- Page: 1 ----------------------
ISO 1004-1:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 1004-1:2013(E)
Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Character configuration . 1
2.1 Designation . 1
2.2 Dimensions . 2
3 Character spacing and alignment . 2
3.1 Spacing . 2
3.2 Alignment . 2
4 Character skew . 2
5 Character tolerances . 3
5.1 Dimensions . 3
5.2 Average edge definition . 3
5.3 Average edge tolerance . 3
5.4 Edge irregularity tolerance . 3
5.5 Extraneous ink — attached .12
5.6 Minimum width of horizontal bars .13
6 Voids .13
6.1 Maximum allowable single voids .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.