ISO 10033-2:2011

INTERNATIONAL ISO
STANDARD 10033-2
First edition
2011-04-15

Laminated Veneer Lumber (LVL) —
Bonding quality —
Part 2:
Requirements
Lamibois — Qualité du collage —
Partie 2: Exigences




Reference number
ISO 10033-2:2011(E)
©
ISO 2011

---------------------- Page: 1 ----------------------
ISO 10033-2:2011(E)

COPYRIGHT PROTECTED DOCUMENT


©  ISO 2011
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2011 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 10033-2:2011(E)
Contents Page
Foreword .iv
1 Scope.1
2 Normative references.1
3 Bonding classes.1
3.1 Class 1 — Dry conditions .1
3.2 Class 2 — Tropical dry/humid conditions.1
3.3 Class 3 — High humid/exterior conditions.2
4 Requirements.2
4.1 General .2
4.2 Pre-treatment .2
4.3 Glueline requirements.2
5 Determination of bonding quality.3

© ISO 2011 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 10033-2:2011(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 10033-2 was prepared by Technical Committee ISO/TC 89, Wood-based panels, Subcommittee SC 3,
Plywood.
ISO 10033 consists of the following parts, under the general title Laminated Veneer Lumber (LVL) — Bonding
quality:
⎯ Part 1: Test methods
⎯ Part 2: Requirements

iv © ISO 2011 – All rights reserved

---------------------- Page: 4 ----------------------
INTERNATIONAL STANDARD ISO 10033-2:2011(E)

Laminated Veneer Lumber (LVL) — Bonding quality —
Part 2:
Requirements
1 Scope
This part of ISO 10033 specifies requ
...