EN ISO 7439:2009

SLOVENSKI STANDARD
01-julij-2009
1DGRPHãþD
SIST EN ISO 7439:2002
SIST EN ISO 7439:2002/kprA1:2009
,QWUDXWHULQLNRQWUDFHSFLMVNLSULSRPRþNL]EDNUHQLPQRVLOFHP=DKWHYHSUHVNXVL
,62
Copper-bearing intra-uterine contraceptive devices - Requirements, tests (ISO
7439:2002)
Kupferhaltige Intrauterinpessare zur Empfängnisverhütung - Anforderungen, Prüfungen
(ISO 7439:2002)
Dispositifs intra-utérins contenant du cuivre - Exigences, essais (ISO 7439:2002)
Ta slovenski standard je istoveten z: EN ISO 7439:2009
ICS:
11.200 1DþUWRYDQMHGUXåLQH Birth control. Mechanical
0HKDQVNLNRQWUDFHSFLMVNL contraceptives
SULSRPRþNL
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN ISO 7439
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2009
ICS 11.200 Supersedes EN ISO 7439:2002
English Version
Copper-bearing intra-uterine contraceptive devices -
Requirements, tests (ISO 7439:2002)
Dispositifs intra-utérins contenant du cuivre - Exigences, Kupferhaltige Intrauterinpessare zur Empfängnisverhütung
essais (ISO 7439:2002) - Anforderungen, Prüfungen (ISO 7439:2002)
This European Standard was approved by CEN on 19 April 2009.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 7439:2009: E
worldwide for CEN national Members.

Contents Page
Foreword .3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 93/42/EEC .4

Foreword
The text of ISO 7439:2002 has been prepared by Technical Committee ISO/TC 150 “Implants for surgery” of
the International Organization for Standardization (ISO) and has been taken over as EN ISO 7439:2009 by
Technical Committee CEN/TC 285 “Non-active surgical implants” the secretariat of which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by November 2009, and conflicting national standards shall be withdrawn
at the latest by March 2010.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 7439:2002.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EC Directive.
For relationship with EC Directive, see informative Annex ZA, which is an integral part of this document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
Endorsement notice
The text of ISO 7439:2002 has been approved by CEN as a EN ISO 7439:2009 without any modification.
Annex ZA
(informative)
Relationship between this European Standard and the Essential Requirements of
EU Directive 93/42/EEC
This European Standard has been prepared under a mandate given to CEN by the European Commission
and the European Free Trade Association to provide a means of conforming to Essential Requirements of the
New Approach Directive 93/42/EEC on medical devices.
Once this standard is cited in the Official Journal of the European Communities under that Directive and has
been implemented as a national standard in at least one Member State, compliance with the clauses of this
standard given in table ZA confers, within the limits of the scope of this standard, a presumption of conformity
with the corresponding Essential Requirements of that Directive and associated EFTA regulations.
Table ZA — Correspondence between this European Standard and Directive 93/42/EEC
Clause(s)/sub-clause(s) of this Essential Requirements (ERs) of Qualifying remarks/Notes
EN Directive 93/42/EEC
4 1, 2, 3, 4, 6 refers to 1st indent of ER 1
5.1 1, 2, 3, 4 refers to 1st indent of ER 1
5.2 1, 2, 9.2 refers to 1st indent of ER 1
5.3.1 1, 2, 9.2 refers to 1st indent of ER 1
5.3.2 3, 4
5.3.3 1, 2 refers to 1st indent of ER 1
5.3.4 1, 2, 9.2 refers to 1st indent of ER 1
5.4 9.2, 12.7.1
5.5.1 5
5.5.2 4
5.6 4
5.7 3, 4
6 7.1, 7.2, 8.1
7.1 1, 2, 3, 4, 6, 8.1 refers to 1st indent of ER 1
7.6 2, 7.1, 7.2, 7.5
7.7 1, 2, 3, 4, 6, 6.a refers to 1st indent of ER 1
8 1, 2, 3, 4, 7.1, 7.2 refers to 1st indent of ER 1
9 8.3, 8.4, 8.5
10 5, 8.3, 8.6
11.1 13.1, 13.2
11.2 13.3 a), 13.3 c) to f), 13.3 m) The part of ER 13.3.a) relating to
the information on the authorized
representative is not addressed
in this European Standard.
11.3 13.3 a), 13.3 d) to f) The part of ER 13.3.a) relating to
the information on the authorized
representative is not addressed
in this European Standard.
11.4 13.3 a) and 13.3 b), 13.3 k), The part of ER 13.3.a) relating to
13.6 b), 13.6 e) and 13.6 f), the information on the authorized
13.6 k), 13.6.l) representative is not addressed
in this European Standard.
11.5 13.4, 13.6 a) and 13.6 b),
13.6 d), 13.6.e), 13.6 i),
13.6 k) to n)
ER 13.3.f) is only partly
addressed: safety issues.
13.6 h) is not addressed in this
European Standard.
13.6 q) is not addressed in this
European Standard.
WARNING — Other requirements and other EU Directives may be applicable to the product(s) falling within
the scope of this standard.
INTERNATIONAL ISO
STANDARD 7439
Second edition
2002-03-15
Copper-bearing intra-uterine contraceptive
devices — Requirements, tests
Dispositifs intra-utérins contenant du cuivre — Spécifications, essais

Reference number
ISO 7439:2002(E)
©
ISO 2002
ISO 7439:2002(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.

©  ISO 2002
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland
ii © ISO 2002 – All rights reserved

ISO 7439:2002(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
International Standard ISO 7439 was prepared by the European Committee for Standardization (CEN) in
collaboration with Technical Committee ISO/TC 157, Mechanical contraceptives, in accordance with the Agreement
on technical cooperation between ISO and CEN (Vienna Agreement).
Throughout the text of this document, read ".this European Standard." to mean ".this International Standard.".
This second edition cancels and replaces the first edition of ISO/TR 7439 (ISO/TR 7439:1981), which has been
technically revised.
Annex ZZ forms a normative part of this International Standard.
Annex ZZ provides a list of corresponding International and European Standards for which equivalents are not
given in the text.
For the purposes of this International Standard, the CEN annex regarding fulfilment of European Council Directives
has been removed.
ISO 7439:2002(E)
Contents
v
Foreword.
vi
Introduction
........................................................................................................................................................
1 Scope 1
......................................................................................................................................................
2 Normative references 1
...............................................................................................................................
3 Terms and definitions 1
...............................................................................................................................
4 Intended performance 2
..............................................................................................................................
5 Design attributes 2
......................................................................................................................................
6 Materials 3
..................................................................................................................................................
7 Design evaluation 3
.....................................................................................................................................
8 Manufacturing and inspection 7
..................................................................................................................
9 Sterilization 7
..............................................................................................................................................
10 Packaging 7
................................................................................................................................................
11 Information supplied by the manufacturer 7
.................................................................................................
Annex ZZ Corresponding International and European Standards for which equivalents are not given
in the text .
Bibliography 11
........................................................................................................................................................
iv © ISO 2002 – All rights reserved

ISO 7439:2002(E)
Foreword
This document (EN ISO 7439:2002) has been prepared by Technical Committee CEN/TC 285 "Non-active surgical

implants", the secretariat of which is held by NEN in collaboration with Technical Committee ISO/TC 157
"Mechanical contraceptives".
This European Standard shall be given the status of a nat
...