EN 3782:2008

SLOVENSKI STANDARD
01-september-2008
Aeronavtika - Luknje za vijake z ugrezno glavo (100°) - Standard za projektiranje
Aerospace series - Holes for 100° countersunk head screws - Design standard
Luft- und Raumfahrt - Löcher für 100°-Senkschrauben - Konstruktionsnorm
Série aérospatiale - Trous pour vis à tête fraisée 100° - Norme de conception
Ta slovenski standard je istoveten z: EN 3782:2008
ICS:
49.030.01 Vezni elementi na splošno Fasteners in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 3782
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2008
ICS 49.030.01
English Version
Aerospace series - Holes for 100° countersunk head screws -
Design standard
Série aérospatiale - Trous pour vis à tête fraisée 100° - Luft- und Raumfahrt - Löcher für 100° -Senkschrauben -
Norme de conception Konstruktionsnorm
This European Standard was approved by CEN on 3 November 2007.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.

EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 3782:2008: E
worldwide for CEN national Members.

Contents Page
Foreword.3
1 Scope.4
2 Use.4
2.1 Normal application.4
2.2 Aerodynamic application.4
3 Required characteristics.4
4 Designation.6
5 Indication in drawings.6

Figures
Figure 1 — Countersunk holes in common parts . 4
Figure 2 — Countersunk holes in sheet metal . 5
Figure 3 — Indication in drawings .
...