EN ISO 8849:2003

SLOVENSKI STANDARD
01-september-2004
1DGRPHãþD
SIST EN 28849:2000
SIST EN 28849:2000/A1:2001
0DODSORYLOD±(OHNWULþQHNDOXåQHþUSDONH]DHQRVPHUQRQDSHWRVW,62
Small craft - Electrically operated direct-current bilge-pumps (ISO 8849:2003)
Kleine Wasserfahrzeuge - Elektrisch angetriebene Gleichstrom- Bilgepumpen (ISO
8849:2003)
Petits navires - Pompes de cale a moteur électrique en courant continu (ISO 8849:2003)
Ta slovenski standard je istoveten z: EN ISO 8849:2003
ICS:
47.020.60 (OHNWULþQDRSUHPDODGLMLQ Electrical equipment of ships
NRQVWUXNFLMQDPRUMX and of marine structures
47.080 ýROQL Small craft
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN ISO 8849
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2003
ICS 47.080 Supersedes EN 28849:1993
English version
Small craft - Electrically operated direct-current bilge-pumps
(ISO 8849:2003)
Petits navires - Pompes de cale à moteur électrique en Kleine Wasserfahrzeuge - Elektrisch angetriebene
courant continu (ISO 8849:2003) Gleichstrom- Bilgepumpen (ISO 8849:2003)
This European Standard was approved by CEN on 1 September 2003.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2003 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 8849:2003 E
worldwide for CEN national Members.

CORRECTED  2003-12-03
Foreword
This document (EN ISO 8849:2003) has been prepared by Technical Committee ISO/TC 188
"Small craft", the secretariat of which is held by CMC.
This European Standard shall be given the status of a national standard, either by publication of
an identical text or by endorsement, at the latest by April 2004, and conflicting national
standards shall be withdrawn at the latest by April 2004.
This document supersedes EN 28849:1993.
This document has been prepared under a mandate given to CEN by the European Commission
and the European Free Trade Association, and supports essential requirements of EU
Directive(s).
For relationship with EU Directive(s), see informative Annex ZB, which is an integral part of this
document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of
the following countries are bound to implement this European Standard: Austria, Belgium, Czech
Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and
the United Kingdom.
Endorsement notice
The text of ISO 8849:2003 has been approved by CEN as EN ISO 8849:2003 without any
modifications.
NOTE Normative references to International Standards are listed in annex ZA (normative).
Annex ZA
(normative)
Normative references to international publications
with their relevant European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions of
any of these publications apply to this European Standard only when incorporated in it by
amendment or revision. For undated references the latest edition of the publication referred to
applies (including amendments).
NOTE Where an International Publication has been modified by common modifications, indicated
by (mod.), the relevant EN/HD applies.
Publication Year Title EN Year
ISO 8846 1990 Small craft - Electrical devices - Protection EN 28846 1993
against ignition of surrounding flammable
gases
ISO 10133 2000 Small craft - Electrical systems - Extra low- EN ISO 10133 2000
voltage d.c. installations
Annex ZB
(informative)
Clauses of this European Standard addressing essential requirements or
other provisions of EU Directives
This European Standard has been prepared under a mandate given to CEN by the European
Commission and the European Free Trade Association and supports essential requirements of
EU Directive 94/25/EEC.
WARNING: Other requirements and other EU Directives may be applicable to the product(s)
falling within the scope of this standard.
The following clauses of this standard, as detailed in table ZA, are likely to support requirements
of Directive 94/25/EEC.
Compliance with the clauses of this standard provides one means of conforming with the specific
essential requirements of the Directive concerned and associated EFTA regulations.
Table ZA: Correspondence between this European Standard and EU Directives
Clauses/sub-clauses of Corresponding Comments
this European Standard annexes/paragraphs of Directive
94/25/EEC
All clauses Annex I, Clause 3.5, Flooding Electric bilge pumps in
compliance with this
Annex I, Clause 5.3, Electrical standard are designed to be
system suitable for recreational craft
4.2 Annex II, Components, 1, Ignition-
protected equipment for inboard and
stern drive engines
INTERNATIONAL ISO
STANDARD 8849
Second edition
2003-10-01
Small craft — Electrically operated direct-
current bilge pumps
Petits navires — Pompes de cale à moteur électrique en courant
continu
Reference number
ISO 8849:2003(E)
©
ISO 2003
ISO 8849:2003(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.

©  ISO 2003
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2003 — All rights reserved

ISO 8849:2003(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical com
...