• Amendment
    13 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Amendment
    13 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This document contains limits and procedures for the measurement of radio disturbances in the
frequency range of 150 kHz to 5 925 MHz. This document applies to vehicles, boats, internal
combustion engines, trailers, devices and any electronic/electrical component intended for use
in vehicles, boats, trailers and devices. Refer to International Telecommunications Union (ITU)
publications for details of frequency allocations. The limits are intended to provide protection
for on-board receivers installed (per the manufacturer’s guidelines) in a vehicle from
disturbances produced by components/modules in the same vehicle.
The receiver types to be protected are, for example, broadcast receivers (sound and television),
land mobile radio, radio telephone, amateur, citizens' radio, Satellite Navigation (GPS etc.), WiFi, V2X, and Bluetooth.
This document does not include protection of electronic control systems from radio frequency
(RF) emissions or from transient or pulse-type voltage fluctuations. These subjects are included
in ISO publications.
The limits in this document are recommended and subject to modification as agreed between
the customer (e.g. vehicle manufacturer) and the supplier (e.g. component manufacturer). This
document is also intended to be applied by vehicle manufacturers and suppliers which are to
be added and connected to the vehicle harness or to an on-board power connector after delivery
of the vehicle.
This document defines test methods for use by vehicle manufacturers and suppliers, to assist
in the design of vehicles and components and ensure controlled levels of on-board radio
frequency emissions.
The emission requirements in this document are not intended to be applicable to the intentional
transmissions from a radio transmitter as defined by the ITU including their spurious emissions.
NOTE 1 This exclusion is limited to those intended transmitter emissions, which leave the EUT as radiated
emissions and are coupled onto the wire line in the measurement setup. For conducted transmissions on frequencies
intentionally produced by the radio part of an EUT, this exclusion does not apply.
NOTE 2 It is usual for customers and suppliers to use radio regulation standards to manage the effect of spurious
emissions from a radio transmitter unless limits of spurious emission are agreed in the test plan.

  • Standard
    186 pages
    English language
    sale 10% off
    e-Library read for
    1 day

2019-08-28: Vote rejected at IEC level - Second CDV to be launched 2019-08-30.
2019-07-04 NEXT STEP: awaiting IEC publication

  • Standard
    27 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    27 pages
    English language
    sale 10% off
    e-Library read for
    1 day

ISPR 25:2016 contains limits and procedures for the measurement of radio disturbances in the frequency range of 150 kHz to 2 500 MHz. The standard applies to any electronic/electrical component intended for use in vehicles, trailers and devices. Refer to International Telecommunications Union (ITU) publications for details of frequency allocations. The limits are intended to provide protection for receivers installed in a vehicle from disturbances produced by components/modules in the same vehicle. The method and limits for a complete vehicle (whether connected to the power mains for charging purposes or not) are in Clause 5 and the methods and limits for components/modules are in Clause 6. Only a complete vehicle test can be used to determine the component compatibility with respect to a vehicle's limit. The receiver types to be protected are, for example, broadcast receivers (sound and television), land mobile radio, radio telephone, amateur, citizens' radio, Satellite Navigation (GPS etc.), Wi-Fi and Bluetooth. For the purpose of this standard, a vehicle is a machine, which is self-propelled by an internal combustion engine, electric means, or both. Vehicles include (but are not limited to) passenger cars, trucks, agricultural tractors and snowmobiles. Annex A provides guidance in determining whether this standard is applicable to particular equipment. This fourth edition cancels and replaces the third edition published in 2008. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:
- inclusion of charging mode for electric vehicles (EV) and plug-in electric vehicles (PHEV),
- the methods for chamber validation have been included,
- test methods for shielded power supply systems for high voltages for electric and hybrid electric vehicles have been included,
- overall improvement.
The contents of the corrigendum of October 2017 have been included in this copy

  • Standard
    155 pages
    English language
    sale 10% off
    e-Library read for
    1 day

The limits in this International Standard are designed to provide protection for broadcast receivers in the frequency range of 30 MHz to 1 000 MHz when used in the residential environment. Compliance with this standard may not provide adequate protection for new types of radio transmissions or receivers used in the residential environment nearer than 10 m to the vehicle, boat or device. This standard applies to the emission of electromagnetic energy which may cause interference to radio reception and which is emitted from a) vehicles propelled by an internal combustion engine, electrical means or both (see 3.1); b) boats propelled by an internal combustion engine, electrical means or both (see 3.2). Boats are to be tested in the same manner as vehicles except where they have unique characteristics as explicitly stated in this standard; c) devices equipped with internal combustion engines (see 3.3). See Annex G for a flow chart to help determine the applicability of CISPR 12. This standard does not apply to aircraft, traction systems (railway, tramway and electric trolley bus), or to incomplete vehicles. In the case of a dual-mode trolley bus (e.g. propelled by power from either a.c./d.c. mains or an internal combustion engine), the internal combustion propulsion system must be included, but the a.c./d.c. mains portion of the vehicle propulsion system is excluded from this standard. NOTE 2 Protection of receivers used on board the same vehicle as the disturbance source(s) are covered by CISPR 25. The measurement of electromagnetic disturbances while the vehicle is connected to power mains for charging is not covered in this standard. The user is referred to appropriate IEC and CISPR standards which define measurement techniques and limits for this condition. Annex H lists work being considered for future revisions.

  • Amendment
    6 pages
    English language
    sale 10% off
    e-Library read for
    1 day

The limits in this International Standard are designed to provide protection for broadcast receivers in the frequency range of 30 MHz to 1 000 MHz when used in the residential environment. Compliance with this standard may not provide adequate protection for new types of radio transmissions or receivers used in the residential environment nearer than 10 m to the vehicle, boat or device. This standard applies to the emission of electromagnetic energy which may cause interference to radio reception and which is emitted from a) vehicles propelled by an internal combustion engine, electrical means or both; b) boats propelled by an internal combustion engine, electrical means or both. Boats are to be tested in the same manner as vehicles except where they have unique characteristics as explicitly stated in this standard; c) devices equipped with internal combustion engines. This sixth edition cancels and replaces the fifth edition published in 2001 and its Amendment 1 (2005). This edition constitutes a technical revision. The following changes were made with respect to the previous edition: - deletion of narrowband / broadband determination; - general improvement of wording.

  • Standard
    58 pages
    English language
    sale 10% off
    e-Library read for
    1 day

CISPR 25:2008 contains limits and procedures for the measurement of radio disturbances in the frequency range of 150 kHz to 2 500 MHz. The standard applies to any electronic/electrical component intended for use in vehicles, trailers and devices. Refer to International Telecommunications Union (ITU) publications for details of frequency allocations. The limits are intended to provide protection for receivers installed in a vehicle from disturbances produced by components/modules in the same vehicle. The method and limits for a complete vehicle are in Clause 5 and the methods and limits for components/modules are in Clause 6. Only a complete vehicle test can be used to determine the component compatibility with respect to a vehicle's limit. The receiver types to be protected are, for example, broadcast receivers (sound and television), land mobile radio, radio telephone, amateur, citizens' radio, Satellite Navigation (GPS, etc.) and Bluetooth. For the purpose of this standard, a vehicle is a machine, which is self-propelled. Vehicles include (but are not limited to) passenger cars, trucks, agricultural tractors and snowmobiles. Annex A provides guidance in determining whether this standard is applicable to particular equipment. The limits in this standard are recommended and subject to modification as agreed between the vehicle manufacturer and the component supplier. This standard is also intended to be applied by manufacturers and suppliers of components and equipment which are to be added and connected to the vehicle harness or to an on-board power connector after delivery of the vehicle. This third edition cancels and replaces the second edition published in 2002. The following significant changes were made with respect to the previous edition: - addition of required measurements with both an average detector and a peak or quasi-peak detector; - addition of methods and limits for the protection of new analogue and digital radio services, which cover the frequency range up to 2 500 MHz; - addition of a new measurement method for components (stripline) as an informative Annex G; - addition of the contents of CISPR 21 as Annex H; CISPR 21 in its entirety now becomes obsolete; - deletion of narrowband / broadband determination; - deletion of the Annex on rod antenna characterisation (this is now covered by CISPR 16-1-4); - deletion of the Annex on characterisation of shielded enclosure (CISPR 25 will be amended when the CISPR/D / CISPR/A Joint Task Force on chamber validation finishes its work). The contents of the corrigendum of January 2009 have been included in this copy.

  • Standard
    84 pages
    English language
    sale 10% off
    e-Library read for
    1 day

Numerous test programmes have been conducted using voice transmissions in an attempt to develop a simple, objective measurement which would correlate well with the subjective effects of mobile radio degradation; the results have been partially successful. This CISPR Report summarizes the conclusions which have been reached, gives suggestions for mobile receiver design, and proposes the need for world-wide receiver noise immunity specifications.

  • Standardization document
    10 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This standard is designed to protect receivers from disturbances produced by conducted and radiated emissions arising in a vehicle. Test procedures and limits given are intended to provide provisional control of vehicle-radiated emissions, as well as component/module conducted/radiated emissions of long and short duration. The standard: - establishes a test method for measuring the electromagnetic emissions from the electrical system of a vehicle; - sets limits for the electromagnetic emissions from the electrical system of a vehicle; - establishes test methods for testing on-board components and modules independent from the vehicle; - sets limits for electromagnetic emissions from components to prevent objectionable disturbance to on-board receivers; - classifies automotive components by disturbance duration to establish a range of limits.

  • Standard
    65 pages
    English language
    sale 10% off
    e-Library read for
    1 day

Applies to the emission of broadband and narrowband electromagnetic energy which may cause interference to radio reception and which is emitted from: a) vehicles propelled by an internal combustion engine, electrical means, or both; b) boats propelled by an internal combustion engine, electrical means, or both. c) devices equipped with internal combustion engines. This standard includes limits and test methods for both broadband and narrowband emissions. The limits are designed to provide protection for broadcast receivers in the frequency range of 30 MHz to 1000 MHz when used in a residential environment.

  • Standard
    55 pages
    English language
    sale 10% off
    e-Library read for
    1 day