CEN/SS T03 - Road vehicles

This International Standard specifies the dimensions and electrical characteristics of the double-pole connection
required for the interchangeability of the electrical connections used to supply additional appliances in road vehicles
with a nominal supply voltage of 12V or 24 V d.c.

Specifies the minimum requirements to allow efficient lashing and securing of semi-trailers, as defined in ISO 3833, on board Ro/Ro ships, indicating in particular the lashing arrangements on the semi-trailer and the securing method to be used. Annex A gives, for information to semi-trailer designers, the securing point arrangements generally used on Ro/Ro ships, annex B describes for information some design indications to decrease damage during handling.

Specifies the minimum requirements to allow efficient lashing and securing of road vehicles on board roll-on/roll-off ships. Applies to goods vehicles, semi-trailer towing vehicles, road trains, and combination of vehicles with a maximum authorized total mass of vehicle and cargo, as defined in ISO 1176, of between 3,5 t and 40 t. Does not apply to passenger cars, buses, and special vehicles.

ISO 8092:2005 defines terms and specifies test methods and general performance requirements for single-pole and multi-pole connections used with on-board electrical wiring harnesses of road vehicles.
It is applicable to connectors designed to be disconnected after mounting in the vehicle for repair and maintenance only. It does not cover one-part connections, i.e. where one part of the connection has direct contact to the pattern of the printed circuit board.
ISO 8092:2005 is not applicable to internal connections of electronic devices.

Gives dimensions for the tabs of multi-pole connections and specific requirements, for on-board electrical wiring harnesses of road vehicles. Does apply to connections designed to be disconnected after mounting in the vehicle for the purposes of repair and/or maintenance only.

Specifies dimensions for the pins of single- and multi-pole connections and specific requirements, for on-board electrical wiring harnesses of road vehicles. Applies to connections designed to be disconnected after mounting in the vehicle in the case of repair and/or maintenance only.

Gives dimensions for the tabs of single-pole connections and specific requirements, for on-board electrical wiring harnesses of road vehicles. Does apply to connections designed to be disconnected after mounting in the vehicle for the purposes of repair and/or maintenance only.

Serves as a generic specification providing the basis for the sectional standards which apply to individual connector types. Establishes uniform concepts and procedures concerning :
-terminology;
-standard ratings and characteristics;
-testing and measuring procedures concerning electrical  electrical and mechanical properties;
-classification of connectors with regard to environmental testing procedures involving temperature, humidity and vibration.