SIST EN 300 113-2 V1.3.1:2004

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Electromagnetic compatibility and Radio spectrum Matters (ERM); Land mobile service; Radio equipment intended for the transmission of data (and/or speech) using constant or non-constant envelope modulation and having an antenna connector; Part 2: Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive33.100.01Elektromagnetna združljivost na splošnoElectromagnetic compatibility in general33.070.01Mobilni servisi na splošnoMobile services in general33.060.99Druga oprema za radijske komunikacijeOther equipment for radiocommunicationsICS:Ta slovenski standard je istoveten z:EN 300 113-2 Version 1.3.1SIST EN 300 113-2 V1.3.1:2004en01-oktober-2004SIST EN 300 113-2 V1.3.1:2004SLOVENSKI
STANDARD
ETSI ETSI EN 300 113-2 V1.3.1 (2003-12) 2
Reference REN/ERM-TG32-046-2 Keywords antenna, data, radio, regulation, speech, mobile, PMR, TDD, TDMA ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: editor@etsi.org Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2003. All rights reserved.
DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTM and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. SIST EN 300 113-2 V1.3.1:2004

ETSI ETSI EN 300 113-2 V1.3.1 (2003-12) 3
Contents Intellectual Property Rights.5 Foreword.5 Introduction.6 1 Scope.8 2 References.8 3 Definitions, symbols and abbreviations.9 3.1 Definitions.9 3.2 Symbols.9 3.3 Abbreviations.9 Technical specifications.9 4.1 Environmental profile.9 4.2 Transmitter requirements.9 4.2.1 Frequency error.9 4.2.1.1 Definition.9 4.2.1.2 Limit.9 4.2.1.3 Method of measurement.9 4.2.2 Carrier power (conducted).10 4.2.2.1 Definition.10 4.2.2.2 Limit.10 4.2.2.3 Method of measurement.10 4.2.3 Effective radiated power.10 4.2.3.1 Definition.10 4.2.3.2 Limit.10 4.2.3.3 Method of measurement.10 4.2.4 Adjacent channel power.10 4.2.4.1 Definition.10 4.2.4.2 Limit.10 4.2.4.3 Method of measurement.10 4.2.5 Spurious emissions.10 4.2.5.1 Definition.10 4.2.5.2 Limit.10 4.2.5.3 Method of measurement.10 4.2.6 Intermodulation attenuation.11 4.2.6.1 Definition.11 4.2.6.2 Limit.11 4.2.6.3 Method of measurement.11 4.2.7 Transmitter attack time.11 4.2.7.1 Definition.11 4.2.7.2 Limit.11 4.2.7.3 Method of measurement.11 4.2.8 Transmitter release time.11 4.2.8.1 Definition.11 4.2.8.2 Limit.11 4.2.8.3 Method of measurement.11 4.2.9 Transient frequency behaviour of the transmitter.11 4.2.9.1 Definition.11 4.2.9.2 Limit.11 4.2.9.3 Method of measurement.11 4.3 Receiver requirements.12 4.3.1 Sensitivity (data or messages).12 4.3.1.1 Definition.12 4.3.1.2 Limit.12 4.3.1.3 Method of measurement.12 4.3.2 Co-channel rejection.12 4.3.2.1 Definition.12 SIST EN 300 113-2 V1.3.1:2004

ETSI ETSI EN 300 113-2 V1.3.1 (2003-12) 4
4.3.2.2 Limit.12 4.3.2.3 Method of measurement.12 4.3.3 Adjacent channel selectivity.12 4.3.3.1 Definition.12 4.3.3.2 Limit.12 4.3.3.3 Method of measurement.12 4.3.4 Spurious response rejection.12 4.3.4.1 Definition.12 4.3.4.2 Limit.12 4.3.4.3 Method of measurement.13 4.3.5 Intermodulation response rejection.13 4.3.5.1 Definition.13 4.3.5.2 Limit.13 4.3.5.3 Method of measurement.13 4.3.6 Blocking or desensitization.13 4.3.6.1 Definition.13 4.3.6.2 Limit.13 4.3.6.3 Method of measurement.13 4.3.7 Spurious radiations.13 4.3.7.1 Definition.13 4.3.7.2 Limit.13 4.3.7.3 Method of measurement.13 4.3.8 Desensitization and sensitivity (duplex).13 4.3.8.1 Definition.13 4.3.8.2 Limit.13 4.3.8.3 Method of measurement.14 4.3.9 Spurious response rejection (duplex).14 4.3.9.1 Definition.14 4.3.9.2 Limit.14 4.3.9.3 Methods of measurement.14 5 Testing for compliance with technical requirements.14 5.1 Environmental conditions for testing.14 5.1.1 Normal and extreme test-conditions.14 5.1.2 Test power source.14 5.1.3 Choice of samples for test suites.14 5.2 Interpretation of the measurement results.14 5.3 Essential radio test suites.15 5.3.1 Frequency error.15 5.3.2 Carrier power (conducted).15 5.3.3 Effective radiated power.15 5.3.4 Adjacent channel power.15 5.3.5 Spurious emissions.15 5.3.6 Intermodulation attenuation.15 5.3.7 Transmitter attack time.15 5.3.8 Transmitter release time.16 5.3.9 Transient frequency behaviour of the transmitter.16 5.3.10 Receiver Spurious radiations.16 5.4 Other radio test suites.16 5.4.1 Sensitivity (data or messages).16 5.4.2 Co-channel rejection.16 5.4.3 Adjacent channel selectivity.16 5.4.4 Spurious response rejection.16 5.4.5 Intermodulation response rejection.16 5.4.6 Blocking or desensitization.16 5.4.7 Desensitization and sensitivity (duplex).16 5.4.8 Spurious response rejection (duplex).16 Annex A (informative): Bibliography.17 Annex B (informative): The EN title in the official languages.18 History.19 SIST EN 300 113-2 V1.3.1:2004

ETSI ETSI EN 300 113-2 V1.3.1 (2003-12) 5
Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http://webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Candidate Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM).
The present document has been produced by ETSI in response to a mandate from the European Commission issued under Council Directive 98/34/EC (as amended) laying down a procedure for the provision of information in the field of technical standards and regulations. The present document is intended to become a Harmonized Standard, the reference of which will be published in the Official Journal of the European Communities referencing the Directive 1999/5/EC [1] of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity ("the R&TTE Directive"). The present document is part 2 of a multi-part
...