ISO/TS 16829:2017
(Main)Non-destructive testing — Automated ultrasonic testing — Selection and application of systems
Non-destructive testing — Automated ultrasonic testing — Selection and application of systems
The information in ISO/TS 16829:2017 covers all kinds of ultrasonic testing on components or complete manufactured structures for either correctness of geometry, for material properties (quality or defects), and for fabrication methodology (e.g. weld testing). ISO/TS 16829:2017 enables the user, along with a customer specification, or a given test procedure or any standard or regulation to select: - ultrasonic probes, probe systems and controlling sensors; - manipulation systems including controls; - electronic sub-systems for the transmission and reception of ultrasound; - systems for data storage and display; - systems and methods for evaluation and assessment of test results. With regard to their performance, ISO/TS 16829:2017 also describes procedures for the verification of the performance of the selected test system. This includes - tests during the manufacturing process of products (stationary testing systems), and - tests with mobile systems.
Essais non destructifs — Contrôle automatisé par ultrasons — Sélection et application des systèmes
General Information
Standards Content (Sample)
TECHNICAL ISO/TS
SPECIFICATION 16829
First edition
2017-10
Non-destructive testing — Automated
ultrasonic testing — Selection and
application of systems
Essais non destructifs — Contrôle automatisé par ultrasons —
Sélection et application des systèmes
Reference number
ISO/TS 16829:2017(E)
©
ISO 2017
---------------------- Page: 1 ----------------------
ISO/TS 16829:2017(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2017 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/TS 16829:2017(E)
Contents Page
Foreword .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Basic system description . 2
4.1 Systems . 2
4.2 System schematic . 3
4.3 Levels of automation . 5
5 Examination of technical objectives and conditions of the testing . 6
5.1 Test task . 6
5.2 Other important conditions . 6
5.2.1 General. 6
5.2.2 Scanning density, test speed, extent and coverage of testing . 6
5.2.3 Environment . 7
5.2.4 Material properties . 7
5.2.5 Complex component geometry . 8
5.3 Test data . 8
5.4 Reference blocks . 8
6 Components and features of an automated test system . 8
6.1 General .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.