ISO 17247:2005

SLOVENSKI STANDARD
SIST ISO 17247:2006
01-oktober-2006
3UHPRJ±.HPLþQDDQDOL]D
Coal -- Ultimate analysis
Charbon -- Analyse élémentaire
Ta slovenski standard je istoveten z: ISO 17247:2005
ICS:
73.040 Premogi Coals
SIST ISO 17247:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ISO 17247:2006

---------------------- Page: 2 ----------------------

SIST ISO 17247:2006

INTERNATIONAL ISO
STANDARD 17247
First edition
2005-05-01


Coal — Ultimate analysis
Charbon — Analyse élémentaire





Reference number
ISO 17247:2005(E)
©
ISO 2005

---------------------- Page: 3 ----------------------

SIST ISO 17247:2006
ISO 17247:2005(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


©  ISO 2005
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2005 – All rights reserved

---------------------- Page: 4 ----------------------

SIST ISO 17247:2006
ISO 17247:2005(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 17247 was prepared by Technical Committee ISO/TC 27, Solid mineral fuels, Subcommittee SC 5,
Methods of analysis.

© ISO 2005 – All rights reserved iii

---------------------- Page: 5 ----------------------

SIST ISO 17247:2006

---------------------- Page: 6 ----------------------

SIST ISO 17247:2006
INTERNATIONAL STANDARD ISO 17247:2005(E)

Coal — Ultimate analysis
1 Scope
This International Standard establishes a practice for the ultimate analysis of coal and is intended for general
utilization by the coal industry to provide a basis for comparison of coals.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 333, Coal — Determination of nitrogen — Semi-micro Kjeldahl method
ISO 334, Solid mineral fuels — Determination of total sulfur — Eschka method
ISO 351, Solid mineral fuels — Determination of total sulfur — High temperature combustion method
ISO 589, Hard coal — Determination of total moisture
ISO 609, Sol
...