ISO 13823:2008
(Main)General principles on the design of structures for durability
General principles on the design of structures for durability
ISO 13823:2008 specifies general principles and recommends procedures for the verification of the durability of structures subject to known or foreseeable environmental actions, including mechanical actions, causing material degradation leading to failure of performance. It is necessary to insure reliability of performance throughout the design service life of the structure. Fatigue failure due to cyclic stress is not within the scope of ISO 13823:2008.
Principes généraux du calcul des constructions pour la durabilité
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 13823
First edition
2008-06-15
General principles on the design of
structures for durability
Principes généraux du calcul des constructions pour la durabilité
Reference number
ISO 13823:2008(E)
©
ISO 2008
---------------------- Page: 1 ----------------------
ISO 13823:2008(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2008
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2008 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 13823:2008(E)
Contents Page
Foreword. iv
Introduction . v
1 Scope .1
2 Normative references .1
3 Terms and definitions .1
4 Symbols .4
5 Application .4
6 Basic concepts for verifying durability .5
6.1 General.5
6.2 Structure environment .5
6.3 Transfer mechanisms.5
6.4 Environmental action .5
6.5 Action effects .6
6.6 Limit states .6
7 Durability requirements .7
7.1 Basic durability requirement .7
7.2 Formats for checking durability.8
8 Design life of a structure and its components, t .11
D
8.1 Structure .11
8.2 Components.11
8.3
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.