EN ISO 14002-1:2020

SLOVENSKI STANDARD
01-november-2020
Sistemi ravnanja z okoljem - Smernice za uporabo ISO 14001 pri upoštevanju
okoljskega vidika in pogojev znotraj ISO 14002-1:2019 - 1. del: Splošno (ISO 14002-
1:2019)
Environmental management systems - Guidelines for using ISO 14001 to address
environmental aspects and conditions within an environmental topic area - Part 1:
General (ISO 14002-1:2019)
Umweltmanagementsysteme - Leitlinien für die Nutzung von ISO 14001 zur Behandlung
von Umweltaspekten und -zuständen innerhalb eines Umweltthemengebiets - Teil 1:
Allgemeines (ISO 14002-1:2019)
Ta slovenski standard je istoveten z: EN ISO 14002-1:2020
ICS:
03.100.70 Sistemi vodenja Management systems
13.020.10 Ravnanje z okoljem Environmental management
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN ISO 14002-1
EUROPEAN STANDARD
NORME EUROPÉENNE
September 2020
EUROPÄISCHE NORM
ICS 03.100.70; 13.020.10
English Version
Environmental management systems - Guidelines for using
ISO 14001 to address environmental aspects and
conditions within an environmental topic area - Part 1:
General (ISO 14002-1:2019)
Umweltmanagementsysteme - Leitlinien für die
Nutzung von ISO 14001 zur Behandlung von
Umweltaspekten und -zuständen innerhalb eines
Umweltthemengebiets - Teil 1: Allgemeines (ISO
14002-1:2019)
This European Standard was approved by CEN on 24 August 2020.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 14002-1:2020 E
worldwide for CEN national Members.

Contents Page
European foreword . 3

European foreword
The text of ISO 14002-1:2019 has been prepared by Technical Committee ISO/TC 207 "Environmental
management” of the International Organization for Standardization (ISO) and has been taken over as
secretariat of which is held by CCMC.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by March 2021, and conflicting national standards shall
be withdrawn at the latest by March 2021.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the
United Kingdom.
Endorsement notice
The text of ISO 14002-1:2019 has been approved by CEN as EN ISO 14002-1:2020 without any
modification.
INTERNATIONAL ISO
STANDARD 14002-1
First edition
2019-11
Environmental management
systems — Guidelines for using
ISO 14001 to address environmental
aspects and conditions within an
environmental topic area —
Part 1:
General
Reference number
ISO 14002-1:2019(E)
©
ISO 2019
ISO 14002-1:2019(E)
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved

ISO 14002-1:2019(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Planning actions . 1
4.1 General . 1
4.2 Establish a baseline for the specific environmental topic area . 2
4.3 Determine appropriate actions . 3
4.3.1 General. 3
4.3.2 Types of action . 3
4.3.3 Considerations for decision-making . 3
5 Taking action . 4
5.1 Environmental objectives . 4
5.2 Support actions . 6
5.3 Operational controls . 7
5.3.1 General. 7
5.3.2 Life cycle perspective . 7
5.3.3 Emergency preparedness and response . 8
5.4 Unintended consequences of actions taken . 8
6 Evaluating the effectiveness of actions . 8
6.1 General . 8
6.2 Monitoring, measurement and analysis . 8
7 Improvement . 9
Bibliography .10
ISO 14002-1:2019(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/ directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www .iso .org/ patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO’s adherence to the
World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see www .iso .org/
iso/ foreword .html.
This document was prepared by Technical Committee ISO/TC 207, Environmental management,
Subcommittee SC 1, Environmental management systems.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www .iso .org/ members .html.
iv © ISO 2019 – All rights reserved

ISO 14002-1:2019(E)
Introduction
0.1  Background
Human society faces the challenge of living within planetary boundaries related to, for example, climate
change, freshwater consumption, land-use change and loss of biodiversity. Organizations need to take
into account the limitations these boundaries impose and can drive positive change in line with global
goals for sustainable development, such as those established by the United Nations. The ISO 14000
family of standards can help organizations to protect the environment and respond to changing
environmental conditions in support of these efforts.
Organizations have varying priorities related to environmental management based on their internal
and external contexts, including the surroundings within which they operate, the nature of their
interactions with the environment, as well as the concerns and requirements of their interested
parties. Organizations can benefit from applying a management system with a focus on an area of
interest or concern for environmental management that is of particular relevance for the organization
itself, the sector to which it belongs or public policy. ISO 14001 provides a framework for environmental
management regardless of an organization’s
...