EN ISO 105-P02:1995

SLOVENSKI STANDARD
01-marec-1999
Tekstilije - Preskušanje barvne obstojnosti - Del P02: Barvna obstojnost pri
plisiranju: Parno plisiranje (ISO 105-P02:1993)
Textiles - Tests for colour fastness - Part P02: Colour fastness to pleating: Steam
pleating (ISO 105-P02:1993)
Textilien - Farbechtheitsprüfungen - Teil P02: Farbechtheit gegen Plissieren:
Dampfplissieren (ISO 105-P02:1993)
Textiles - Essai de solidité des teintures - Partie P02: Solidité au pliage: Plissage a la
vapeur (ISO 105-P02:1993)
Ta slovenski standard je istoveten z: EN ISO 105-P02:1995
ICS:
59.080.01 Tekstilije na splošno Textiles in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

ISO
INTERNATIONAL
105-PO2
STANDARD
Second edition
1993-10-01
- Tests for colour fastness -
Textiles
Part PO2
Colour fastness to pleating: Steam pleating
- Essais de solidite des teintures -
Textiles
Partie PO2: Solidite des teintures au pliage: Plissage 5 Ia vapeur
Reference number
ISO 105-PO2:1993(E)
ISO 105-P02:1993(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide
federation of national Standards bodies (ISO member bodies). The work
of preparing International Standards is normally carried out through ISO
technical committees. Esch member body interested in a subject for
which a technical committee has been established has the right to be
represented on that committee. International organizations, governmental
and non-governmental, in liaison with ISO, also take part in the work. ISO
collaborates closely with the International Electrotechnical Commission
(IEC) on all matters of electrotechnical standardization.
Draft International Standards adopted by the technical committees are
circulated to the member bodies for voting. Publication as an International
Standard requires approval by at least 75 % of the member bodies casting
a vote.
International Standard ISO 105-PO2 was prepared by Technical Committee
lSO/TC 38, Textiles, Sub-Committee SC 1, Tests for coloured textiles and
coloran ts.
This second edition cancels and replaces the first edition (included in
ISO 105-P:l978), of which it constitutes a minor revision.
ISO 105 was previously published in thirteen “Parts”, each designated by
a letter (e.g. “Part A”), with publication dates between 1978 and 1985.
Esch part contained a series of “sections”, each designated by the re-
spective part letter and by a two-digit serial number (e.g. “Section AO1 “).
These sections are now being republished as separate documents, them-
selves designated “Parts” but retaining their earlier alphanumeric desig-
nations. A complete list of these Parts is given in ISO 105-AOI .
0 ISO 1993
All rights reserved. No patt of this publication may be reproduced or utilized in any form or
by any means, electronie or mechanical, including photocopying and microfilm, without per-
mission in writing from the publisher.
International Organization for Standardization
Case Postale 56 l CH-l 211 Geneve 20 l Switzerland
Printed in Switzerland
ii
ISO 105-P02:1993(E)
INTERNATIONAL STANDARD
Textiles - Tests for colour fastness -
Part P02:
Colour fastness to pleating: Steam pleating
ISO 105-F:1985, Textiles - Tests for colour fastness
1 Scope
- Part F: Standard adjacent fabrics.
ISO 105-F10:1989, Textiles - Tests for colour fast-
1.1 This part of ISO 105 specifies a method for de-
Part F? 0: Specification for adjacent fabric:
ness -
termining the resistance of the colour of textiles of all
Multifibre.
kinds and in all forms to the action of steam-pleating
processes. The materials are not pleated during the
ISO 139: 1973, Textiles - Standard atmospheres for
test, and it is emphasized that the test is not intended
conditioning and testing.
for assessing the quality of the pleating process.
1.2 Three tests differing in severity are provided; 3 Principle
one or more of them may be used depending on the
requirements. A specimen of the textile in contact with either one
or two specified adjacent fabrics is steamed under
pressure and dried. The Change in colour of the
specimen, and the staining of the adjacent fabric(s),
2 Normative references
are assessed with the grey scales.
The following Standards contain provisions which,
through reference in this text, constitute provisions
4 Apparatus and materials
of this part of ISO 105. At the time of publication, the
editions indicated were valid. All Standards are subject
to revision, and Parties to agreements based on this
4.1 Specimen holder (see figure 1), consisting of a
part of ISO 105 are encouraged to investigate the
topper tube 80 mm in external diameter. The thick-
possibility of applying the most recent editions of the
ness of the topper is 1,5 mm. The topper tube is
Standards indicated below. Members of IEC and ISO
wrapped with six layers of bleached cotton fabric of
maintain registers of currently valid International
mass per unit area approximately 125 g/m*, on which
Standards.
the test specimen is wrapped. Wrapped round the
test specimen is an outer cover made from bleached
ISO 105-AO1 :1989, Textiles - Tests for colour fast-
cotton fabric of mass per unit area approximately
ness - Part AOl: General principles of testing.
185 g/m*. The outer cover is held in place by rods
made from 6-mm-diameter mild steel, spring-fitted to
ISO 105-AO2:1993, Textiles - Tests for colour fast-
the tube.
ness - Part AOZ: Grey scale for assessing Change in
colourO The strength of the springs is not critical, but it shall
be sufficient to hold the cover tightly against the tube.
ISO 105-AO3:1993, Textiles - Tests for colour fast- The springs are conveniently fastened to one of the
ness - Part A03: Grey
...