prEN 14187-5
(Main)Cold applied joint sealants - Test methods - Part 5: Determination of the resistance to hydrolysis
Cold applied joint sealants - Test methods - Part 5: Determination of the resistance to hydrolysis
This European Standard describes a test method for determining the resistance to hydrolysis of cold applied joint sealants after treatment at elevated temperature and high humidity.
Kalt verarbeitbare Fugenmassen - Teil 5: Prüfverfahren zur Bestimmung des Aushärtungsgrades
Diese Europäische Norm beschreibt ein Prüfverfahren zur Bestimmung der Beständigkeit von kalt verarbeitbaren Fugenmassen gegen Hydrolyse nach Beanspruchung bei erhöhter Temperatur und hoher Luftfeuchte.
Mastics pour joints appliqués à froid - Méthodes d'essai - Partie 5: Détermination de la résistance à l'hydrolyse
La présente Norme européenne décrit une méthode d'essai pour la détermination de la résistance à l'hydrolyse des mastics pour joints appliqués à froid après soumission à une température et un taux d'humidité élevés.
Hladno nanosljive tesnilne mase za stike - Preskusne metode - 5. del: Ugotavljanje odpornosti proti hidrolizi
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-december-2014
Hladno nanosljive tesnilne mase za stike - Preskusne metode - 5. del: Ugotavljanje
odpornosti proti hidrolizi
Cold applied joint sealants - Test methods - Part 5: Determination of the resistance to
hydrolysis
Kalt verarbeitbare Fugenmassen - Teil 5: Prüfverfahren zur Bestimmung des
Aushärtungsgrades
Mastics pour joints appliqués à froid - Méthodes d'essai - Partie 5: Détermination de la
résistance à l'hydrolyse
Ta slovenski standard je istoveten z: prEN 14187-5
ICS:
91.100.50 Veziva. Tesnilni materiali Binders. Sealing materials
93.080.20 Materiali za gradnjo cest Road construction materials
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
DRAFT
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2014
ICS 93.080.20 Will supersede EN 14187-5:2003
English Version
Cold applied joint sealants - Test methods - Part 5:
Determination of the resistance to hydrolysis
Mastics pour joints appliqués à froid - Méthodes d'essai - Kalt verarbeitbare Fugenmassen - Teil 5: Prüfverfahren zur
Partie 5: Détermination de la résistance à l'hydrolyse Bestimmung des Aushärtungsgrades
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 227.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 14187-5:2014 E
worldwide for CEN national Members.
Contents
Page
Foreword .3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Principle .4
5 Apparatus and materials .4
6 Preparation of test specimens .4
7 Conditioning .4
8 Procedure .5
8.1 Test temperature .5
8.2 Test period .5
8.3 Test procedure .5
8.4 Calculation and expression of results .5
9 Test report .5
prEN 1418
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.