ISO/TC 115/SC 1 - Dimensions and technical specifications of pumps

ISO 16330:2003 specifies the technical requirements, other than safety and testing, for reciprocating positive displacement pumps and pump units. It applies to pumps which utilize reciprocating motion derived from crankshafts and camshafts and also direct-acting fluid driven pumps. It does not apply to reciprocating positive displacement pumps, nor pumping water, where the whole pump is lubricated with the liquid being pumped.

1.1 This International Standard specifies the requirements for seal-less rotodynamic pumps that are driven with permanent magnet coupling (magnet drive pumps) or with canned motor, and which are mainly used in chemical processes, water treatment and petrochemical industries. Their use can be dictated by space, noise, environment or safety regulations. Seal-less pumps are pumps where an inner rotor is completely contained in a pressure vessel holding the pumped fluid. The pressure vessel or primary containment device is sealed by static seals such as gaskets or O-rings. 1.2 Pumps will normally conform to recognized standard specifications (e.g. ISO 5199, explosion protection, electromagnetic compatibility), except where special requirements are specified herein. 1.3 This International Standard includes design features concerned with installation, maintenance and operational safety of the pumps, and defines those items to be agreed upon between the purchaser and manufacturer/supplier. 1.4 Where conformity to this International Standard has been requested and calls for a specific design feature, alternative designs may be offered providing that they satisfy the intent of this International Standard and they are described in detail. Pumps which do not conform with all requirements of this International Standard may also be offered providing that the deviations are fully identified and described. Whenever documents include contradictory requirements, they should be applied in the following sequence of priority: a) purchase order (or inquiry, if no order placed), see annexes D and E; b) data sheet (see annex A) or technical sheet or specification; c) this International Standard; d) other standards.

Consists of a basic text covering general requirements. The technical requirements refer only to the pump unit. Includes design features concerned with installation, maintenance and safety of such pumps, including baseplate, coupling and auxiliary piping. The selection of the class to be used is made in accordance with the technical requirements for the application for which the pump is intended. The class chosen is to be agreed between purchaser and manufacturer/supplier.

Covers class III requirements for centrifugal pumps of single stage, multistage, horizontal or vertical construction (coupled or close-coupled) with any drive and any installation for general application. Includes design features concerned with installation, maintenance and safety of such pumps including baseplate, coupling and auxiliary piping but excluding the driver, if it is not an integral part of the pump.

Specifies the main parameters and describes the pump designation which consits of three numbers. The table covers flange sizes from 50 mm up to and including 200 mm. A figure shows the side view and the front view of the pump.

17613-1:2006 gives recommendations for the selection and acceptance of manually operated pumps suitable for lifting water, free of sand and/or suspended particles, from shallow and deep borewells situated in Southeast Asia.

Covers class II requirements for pumps of back pull-out construction as used primarily in the chemical and petrochemical industries. Includes design features concerned with installation, maintenance and safety for these pumps, including baseplate couplings and auxiliary piping but excluding the driver.