ECISS/TC 12 - Structural steels and steels for pressure purposes, flat products - Dimensions and tolerances
Standardization of tolerances on dimension, form and mass for hot-rolled flat products of non-alloy and alloy steels with a rolled width > or = 600 mm.
Konstrukcijska jekla in jekla za tlačne posode - ploščati izdelki - mere in tolerance
Standardization of tolerances on dimension, form and mass for hot-rolled flat products of non-alloy and alloy steels with a rolled width > or = 600 mm.
General Information
This European Standard applies to continuously hot-rolled uncoated flat products with a maximum width of 2200 mm of non-alloy and alloy steels including stainless steels in accordance with table 1. This European Standard also applies to hot-rolled strip for cold rolling. This European Standard does not apply to hot-rolled strip rolled in widths < 600 mm (see EN 10048).
- Standard22 pagesEnglish languagesale 10% offe-Library read for1 day
This European Standard specifies requirements for tolerances for hot rolled non-alloy and alloy steel plates including stainless steels, with the following characteristics: a) nominal thickness >= 3mm <=250 mm; b) nominal width >= 600 mm ; c) specified minimum yield strength > 700 N/mm2. Tolerances for products of width < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order.
- Standard14 pagesEnglish languagesale 10% offe-Library read for1 day