SIST EN 14488-4:2005/oprA1:2007
(Amendment)Testing sprayed concrete - Part 4: Bond strength of cores by direct tension
Testing sprayed concrete - Part 4: Bond strength of cores by direct tension
Modifications to German title, Scope and 5.2
Prüfung von Spritzbeton - Teil 4: Haftfestigkeit an Bohrkernen bei zentrischem Zug
Essais pour béton projeté - Partie 4: Adhérence en traction directe sur carottes
Preskušanje brizganega betona - 4. del: Sprijemna trdnost plasti z neposrednim nategom
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 14488-4:2005/oprA1:2007
01-december-2007
Preskušanje brizganega betona - 4. del: Sprijemna trdnost plasti z neposrednim
nategom
Testing sprayed concrete - Part 4: Bond strength of cores by direct tension
Prüfung von Spritzbeton - Teil 4: Haftfestigkeit an Bohrkernen bei zentrischem Zug
Essais pour béton projeté - Partie 4: Adhérence en traction directe sur carottes
Ta slovenski standard je istoveten z: EN 14488-4:2005/prA1
ICS:
91.100.30 Beton in betonski izdelki Concrete and concrete
products
SIST EN 14488-4:2005/oprA1:2007 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
FINAL DRAFT
EN 14488-4:2005
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
September 2007
ICS 91.100.30
English Version
Testing sprayed concrete - Part 4: Bond strength of cores by
direct tension
Essais pour béton projeté - Partie 4: Adhérence en traction Prüfung von Spritzbeton - Teil 4: Haftfestigkeit an
directe sur carottes Bohrkernen bei zentrischem Zug
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 104.
This draft amendment A1, if approved, will modify the European Standard EN 14488-4:2005. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EU
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.