SIST EN 300 676-2 V1.5.1:2011

Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)
Harmonized European Standard

Ground-based VHF hand-held, mobile and
fixed radio transmitters, receivers and
transceivers for the VHF aeronautical mobile service
using amplitude modulation;
Part 2: Harmonized EN covering essential requirements
of article 3.2 of the R&TTE Directive

---------------------- Page: 1 ----------------------
2 Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)



Reference
REN/ERM-JTFEA-007
Keywords
aeronautical, AM, DSB, radio, testing, VHF
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: +33 4 92 94 42 00  Fax: +33 4 93 65 47 16

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2011.
All rights reserved.

TM TM TM TM
DECT , PLUGTESTS , UMTS , TIPHON , the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered
for the benefit of its Members.
TM
3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners.
LTE™ is a Trade Mark of ETSI currently being registered
for the benefit of its Members and of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI

---------------------- Page: 2 ----------------------
3 Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)
Contents
Intellectual Property Rights . 5
Foreword . 5
Introduction . 5
1 Scope . 6
2 References . 6
2.1 Normative references . 6
2.2 Informative references . 6
3 Definitions and abbreviations . 7
3.1 Definitions . 7
3.2 Abbreviations . 7
4 Technical requirements specifications . 8
4.1 Environmental profile . 8
4.2 Conformance requirements . 8
4.2.1 Transmitter requirements . 8
4.2.1.1 Frequency error . 8
4.2.1.2 Carrier power (conducted) . 8
4.2.1.3 Adjacent channel power . 8
4.2.1.4 Conducted spurious emissions . 8
4.2.1.5 Intermodulation attenuation (Applicable to Base stations only) . 8
4.2.1.6 Keying transient frequency behaviour (Applicable to base stations only) . 8
4.2.1.7 Cabinet radiation . 8
4.2.2 Receiver requirements . 9
4.2.2.1 Sensitivity . 9
4.2.2.2 Adjacent channel rejection . 9
4.2.2.3 Spurious response rejection . 9
4.2.2.4 Intermodulation response rejection . 9
4.2.2.5 Blocking or desensitisation . 9
4.2.2.6 Conducted spurious emissions . 9
4.2.2.7 Cross modulation rejection . 9
4.2.2.8 Cabinet radiation . 9
5 Testing for compliance with technical requirements . 9
5.1 Environmental conditions for testing . 9
5.2 Interpretation of the measurement results . 10
5.3 Essential radio test suites . 10
5.3.1 Transmitter test specifications . 10
5.3.1.1 Frequency error . 10
5.3.1.2 Carrier power (conducted) . 10
5.3.1.3 Adjacent channel power . 11
5.3.1.4 Conducted spurious emissions . 11
5.3.1.5 Intermodulation attenuation . 11
5.3.1.6 Keying transient frequency behaviour . 11
5.3.1.7 Cabinet Radiation . 11
5.3.2 Receiver test specifications . 11
5.3.2.1 Sensitivity . 11
5.3.2.2 Adjacent channel rejection . 11
5.3.2.3 Spurious response rejection . 11
5.3.2.4 Intermodulation response rejection . 11
5.3.2.5 Blocking or desensitisation . 11
5.3.2.6 Conducted spurious emissions . 11
5.3.2.7 Cross modulation rejection . 11
5.3.2.8 Cabinet radiation . 11
ETSI

---------------------- Page: 3 ----------------------
4 Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)
Annex A (normative): HS Requirements and conformance Test specifications Table (HS-
RTT) . 12
Annex B (informative): The EN title in the official languages . 15
Annex C (informative): Bibliography . 16
History . 17

ETSI

---------------------- Page: 4 ----------------------
5 Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://webapp.etsi.org/IPR/home.asp).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This final draft Harmonized European Standard (EN) has been produced by ETSI Technical Committee
Electromagnetic compatibility and Radio spectrum Matters (ERM), and is now submitted for the ETSI standards
One-step Approval Procedure.
The present document has been produced by ETSI in response to a mandate from the European Commission issued
under Council Directive 98/34/EC (as amended) [i.4] laying down a procedure for the provision of information in the
field of technical standards and regulations.
The title and reference to the present document are intended to be included in the publication in the Official Journal of
the European Union of titles and references of Harmonized Standard under the Directive 1999/5/EC [i.1].
See article 5.1 of Directive 1999/5/EC [i.1] for information on presumption of conformity and Harmonised Standards or
parts thereof the references of which have been published in the Official Journal of the European Union.
The requirements relevant to Directive 1999/5/EC [i.1] are summarised in annex A.
The present document is part 2 of a multi-part deliverable covering the Ground-based VHF hand-held, mobile and fixed
radio transmitters, receivers and transceivers for the VHF aeronautical mobile service using amplitude modulation; as
identified below:
Part 1: "Technical characteristics and methods of measurement";
Part 2: "Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive".

Proposed national transposition dates
Date of latest announcement of this EN (doa): 3 months after ETSI publication
Date of latest publication of new National Standard
or endorsement of this EN (dop/e): 6 months after doa
Date of withdrawal of any conflicting National Standard (dow): 18 months after doa

Introduction
The present document is part of a set of standards developed by ETSI and is designed to fit in a modular structure to
cover all radio and telecommunications terminal equipment within the scope of the R&TTE Directive [i.1]. The
modular structure is shown in EG 201 399 [i.3].
ETSI

---------------------- Page: 5 ----------------------
6 Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)
1 Scope
The present document applies to DSB AM ground base stations, with channel separations of 8,33 kHz or 25 kHz
intended for analogue speech intended for ACARS data communication. The scope of the present document is limited
to ground based stations, ground mobile and hand held radios for ground use. These radio equipment types are capable
of operating in all or any part of the Aeronautical frequency band- between 118 MHz and 136,975 MHz.
The present document is intended to cover the provisions of Directive 1999/5/EC (R&TTE Directive) [i.1], article 3.2,
which states that ". radio equipment shall be so constructed that it effectively uses the spectrum allocated to
terrestrial/space radio communications and orbital resources so as to avoid harmful interference".
In addition to the present document, other ENs that specify technical requirements in respect of essential requirements
under other parts of article 3 of the R&TTE Directive [i.1] as well as essential requirements under the Single European
Sky Interoperability Regulation (as amended) [2] and related implementing rules may apply to equipment within the
scope of the present document.
NOTE: A list of such ENs is included on the web site http://www.newapproach.org.
2 References
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
reference document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication ETSI cannot guarantee
their long term validity.
2.1 Normative references
The following referenced documents are necessary for the application of the present document.
[1] ETSI EN 300 676-1 (V1.5.2): "Ground-based VHF hand-held, mobile and fixed radio transmitters,
receivers and transceivers for the VHF aeronautical mobile service using amplitude modulation;
Part 1: Technical characteristics and methods of measurement".
[2] ETSI EN 300 113-1 (V1.6.1): "Electromagnetic compatibility and Radio spectrum Matters (ERM);
Land mobile service; Radio equipment intended for the transmission of data (and/or speech) using
constant or non-constant envelope modulation and having an antenna connector; Part 1: Technical
characteristics and methods of measurement".
[3] ETSI TR 100 028 (all parts) (V1.4.1): "Electromagnetic compatibility and Radio spectrum Matters
(ERM); Uncertainties in the measurement of mobile radio equipment characteristics".
2.2 Informative references
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio
equipment and telecommunications terminal equipment and the mutual recognition of their
conformity; amended by Regulation (EC) No 1882/2003 of the European Parliament and of the
Council of 29/09/2003.
ETSI

---------------------- Page: 6 ----------------------
7 Final draft ETSI EN 300 676-2 V1.5.0 (2011-04)
[i.2] Regulation (EC) 552/2004 of the European Parliament and Council of 10 March 2004 on the
interoperability of the European Air Traffic Management network (the interoperability
Regulation); Officia
...