ISO 603-18:2013

INTERNATIONAL ISO
STANDARD 603-18
First edition
2013-01-15
Bonded abrasive products —
Dimensions —
Part 18:
Grinding wheels for flat glass edge
grinding machines
Produits abrasifs agglomérés — Dimensions —
Partie 18: Meules pour machines à meuler les bords de verre plat
Reference number
©
ISO 2013
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Requirements . 1
3.1 Shapes and dimensions . 1
3.2 Designation . 6
3.3 Specifications. 6
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International
Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies
casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 603-18 was prepared by Technical Committee ISO/TC 29, Small tools, Subcommittee SC 5, Grinding
wheels and abrasives.
ISO 603 consists of the following parts, under the general title Bonded abrasive products — Dimensions:
— Part 1: Grinding wheels for external cylindrical grinding between centres
— Part 2: Grinding wheels for centreless external cylindrical grinding
— Part 3: Grinding wheels for internal cylindrical grinding
— Part 4: Grinding wheels for surface grinding/peripheral grinding
— Part 5: Grinding wheels for surface grinding/face grinding
— Part 6: Grinding wheels for tool and tool room grinding
— Part 7: Grinding wheels for manually guided grinding
— Part 8: Grinding wheels for deburring and fettling/snagging
— Part 9: Grinding wheels for high-pressure grinding
— Part 10: Stones for honing and superfinishings
— Part 11: Hand finishing sticks
— Part 12: Grinding wheels for deburring and fettling on a straight grinder
— Part 13: Grinding wheels for deburring and fettling on a vertical grinder
— Part 14: Grinding wheels for deburring and fettling/snagging on an angle grinder
— Part 15: Grinding wheels for cutting-off on stationary or mobile cutting-off machines
— Part 16: Grinding wheels for cutting-off on hand held power tools
— Part 17: Mounted wheels
— Part 18: Grinding wheels for flat glass edge grinding machines
iv © ISO 2013 – All rights reserved
...