ISO 12466-1:2007

INTERNATIONAL ISO
STANDARD 12466-1
Second edition
2007-11-15


Plywood — Bonding quality —
Part 1:
Test methods
Contreplaqué — Qualité du collage —
Partie 1: Méthodes d'essai




Reference number
ISO 12466-1:2007(E)
©
ISO 2007

---------------------- Page: 1 ----------------------
ISO 12466-1:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2007 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 12466-1:2007(E)
Contents Page
Foreword. iv
1 Scope . 1
2 Normative references . 1
3 Test pieces . 1
3.1 Sampling. 1
3.2 Shape and size. 1
4 Apparatus . 5
4.1 Pre-treatment. 5
4.2 Shear test. 5
5 Pre-treatment. 5
5.1 Sequence of pre-treatment . 5
5.2 Positioning of test pieces . 5
6 Procedure . 6
6.1 Determination of behaviour of ply bonding by shear test. 6
6.2 Determination of percentage of apparent cohesive wood failure . 6
6.3 Alternative procedure. 6
7 Expression of results . 6
8 Test report . 7
Annex A (normative) Determination of percentage of apparent cohesive wood failure by
comparison with reference illustrations. 8
Annex B (normative) Bond testing and evaluation using the chisel/knife testing procedures
(suitable for qualit
...