ISO 17612:2004

INTERNATIONAL ISO
STANDARD 17612
First edition
2004-02-15
Tractors and machinery for agriculture
and forestry — Auxiliary-power-
transmission connector for the operator
station
Tracteurs et matériels agricoles et forestiers — Connecteur de
transmission d'énergie auxiliaire au poste de l'opérateur

Reference number
ISO 17612:2004(E)
©
ISO 2004

---------------------- Page: 1 ----------------------
ISO 17612:2004(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall
not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the
unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2004
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56  CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
©
ii ISO 2004 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 17612:2004(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 17612 was prepared by Technical Committee ISO/TC 23, Tractors and machinery for agriculture and
forestry, Subcommittee SC 4, Tractors.
©
ISO 2004 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 17612:2004(E)
Introduction
This International Standard specifies an electrical connector for the transmission of auxiliary power within the
operator station of enclosed agricultural machines. The specification thus established will allow manufacturers
to provide both individual and multiple outlets in the cab. Typical applications include monitors, light-duty
controllers, remote operating devices and miscellaneous off-the-shelf items. Only the application dimensions
and electrical characteristics are covered.
Other electrical transmission connectors for agricultural tractors and machinery are specified in ISO/TR 12369.
For this and other International Standards dealing with connectors for electrical power transmission from tractor
to implement or other means, see the Bibliography.
©
iv ISO 2004 – All rights reserved

---------------------- Page: 4 ----------------------
INTERNATIONAL STANDARD ISO 17612:2004(E)
Tractors and machinery for agriculture and forestry — Auxiliary-
power-transmission connector for the operator station
1Scope
This International Standard specifies the essential interface dimensions of a connector and its plug for the
transmission of 12 V electrical power within the enclosed operator station of agricultural tractors and machinery.
The device is intended to be used as a non-environmentally sealed, convenient source for power auxiliary
devices, providing a means for the operator to obtain electrical power without altering the tractor/machine
electrical wiring harness. The maximum current capacity of the specified device is 30 A: it is not applicable to
any other voltage system (6 V or 24 V).
2 Normative references
The follo
...