ISO 11452-2:2019
(Main)Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 2: Absorber-lined shielded enclosure
Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 2: Absorber-lined shielded enclosure
This document specifies an absorber-lined shielded enclosure method for testing the immunity (off-vehicle radiation source) of electronic components for passenger cars and commercial vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor). The device under test (DUT), together with the wiring harness (prototype or standard test harness), is subjected to an electromagnetic disturbance generated inside an absorber-lined shielded enclosure, with peripheral devices either inside or outside the enclosure. It is applicable only to disturbances from continuous narrowband electromagnetic fields. See ISO 11452-1 for general test conditions.
Véhicules routiers — Méthodes d'essai d'un équipement soumis à des perturbations électriques par rayonnement d'énergie électromagnétique en bande étroite — Partie 2: Chambre anéchoïque
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 11452-2
Third edition
2019-01
Road vehicles — Component test
methods for electrical disturbances
from narrowband radiated
electromagnetic energy —
Part 2:
Absorber-lined shielded enclosure
Véhicules routiers — Méthodes d'essai d'un équipement soumis
à des perturbations électriques par rayonnement d'énergie
électromagnétique en bande étroite —
Partie 2: Chambre anéchoïque
Reference number
ISO 11452-2:2019(E)
©
ISO 2019
---------------------- Page: 1 ----------------------
ISO 11452-2:2019(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 11452-2:2019(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Test conditions . 1
5 Test location . 2
6 Test apparatus and instrumentation. 2
6.1 General . 2
6.2 Measuring equipment . 2
6.3 Stimulation and monitoring of DUT . 3
7 Test set-up for DUT powered by an unshielded power system . 3
7.1 Ground plane . 3
7.2 Power supply and AN . 3
7.3 Location of DUT . 4
7.4 Location of test harness . 4
7.5 Location of load simulator . 4
7.6 Location of field generating device (antenna) . 4
8 Test setu
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.