ISO 13470:2012
(Main)Trenchless applications of ductile iron pipes systems — Product design and installation
Trenchless applications of ductile iron pipes systems — Product design and installation
1 Scope This International Standard specifies the requirements, test methods and installation technologies applicable to ductile iron pipes used in trenchless applications: — to convey water or wastewater; — operated with or without pressure. NOTE In this International Standard, all pressures are relative pressures expressed in bar(s)1). This International Standard specifies materials, dimensions and tolerances, mechanical properties and standard coatings of pipes, fittings and accessories. It also gives performance requirements for all components including joints. Joint design and gasket shapes are outside the scope of this International Standard. This International Standard applies to pipes, fittings and accessories cast by any type of foundry process or manufactured by fabrication of cast components, as well as corresponding joints, of a size range DN 80 to DN 2 600 inclusive.
Application des systèmes de canalisations en fonte ductile en pose sans tranchée — Conception des produits et mise en oeuvre
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 13470
First edition
2012-07-01
Trenchless applications of ductile iron
pipes systems — Product design and
installation
Application des systèmes de canalisations en fonte ductile en pose
sans tranchée — Conception des produits et mise en oeuvre
Reference number
ISO 13470:2012(E)
©
ISO 2012
---------------------- Page: 1 ----------------------
ISO 13470:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 13470:2012(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Trenchless technologies . 3
4.1 General . 3
4.2 Horizontal directional drilling (HDD) . 3
4.3 Pipe bursting (PB) . 5
4.4 Casing method (CM) . 6
4.5 Pipe jacking (PJ) . 7
5 Technical requirements . 8
5.1 General requirements . 8
5.2 Coatings and linings for pipes .10
5.3 Joint protection . 11
6 Performance requirements joints .12
6.1 General requirements .12
6.2 Requirements for joints for pulling methods .12
6.3 Joints for pushing method.13
7 Test methods .15
7.1 Pulling force resistance measurement .15
7.2 Pushing force resistance .15
8 Laying procedure .16
8.1 General .16
8.2 Pulling methods .16
8.3
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.