ISO/IEC 10021-5:1990/Cor 5:1992

INTERNATIONAL STANDARD ISO/IEC 10021 -5:1990
TECHNICAL CORRIGENDUM 5
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION. MEXAYHAPOAHAR OPTAHH3AuMR no CTAHflAPTH3AuMH. ORGANISATION INTERNATIONALE DE NORMALISATION
INTERNATIONAL ELECTROTECHNICAL COMMlSSlON s MEXAYHAPOflHAR 3nEKTPOTEXHL4'4ECKAR KOMMCCHR - COMMISSION ELECTROTECHNIûUE INTERNATIONALE
lnformation technology - Text Communication - Message-
Oriented Text Interchange Systems (MOTIS) -
Part 5:
Message Store: Abstract Service Definition
TECHNICAL CORRIGENDUM 5
Technologies de l'information - Communication de texte - Systèmes d'échange de texte en mode message -
Partie 5: Dépôt de message: Définition de service abstrait
RECTlFlCATlF TECHNlQUE 5
Technical corrigendum 5 to International Standard ISO/IEC 10021-5:1990 was prepared by Joint Technical Committee
ISO/IEC JTC 1, lnformation technology.
Page 1
Clause 1
Replace the last sentence starting: "No requirement ,.'I with "The requirements for conformance to this part of ISODEC 10021
are stated in clause 10 of ISO/iEC 10021-6.".
UDC 681.3 : 621.39 Ref. No. ISO/IEC 10021-51990/Cor.51992 (E)
Descriptors : data processing, information interchange, network interconnection, open systems interconnection, data transmission, text
communication, messages, definitions.
O ISO/IEC1992
Printed in Switzerland
ISOIIEC 10021-5 : 1990/Cor.5 : 1992 (E)
Page IO
Subclause 5.2
In the third paragraph (starting 'For the column headed "Support level by MS and access UA') replace:
"M mandatory"
by:
"M mandatory for the MS and the access UA
M* mandatory for the MS"
Page 28
Subclause 8.1.2.2 (as replaced by Technical Corrigendum 3)
e
In bullet c), replace "places the supplied value before (i.e. less than) or equal to any value of the attribute" by "places a value
of the attribute after (i.e. greater than) or equal to the supplied value".
In bullet d), replace "places the supplied value after (i.e. greater than) or equal to any value of the attribute" by "places a value
of the attribute before (i.e. less than) or equal to the supplied value".
Page 31
Subclause 8.1.4
In the third sentence of bullet 2) replace "only be present" with "be present only". In the fourth sentence of bullet 2) replace
"If it is omitted with "If this component is omitted.
In the first sentence of bullet 3) insert "maximum" before "number". Replace the second sentence of bullet 3) with "It is not an
error if count is greater than the number of values present in the entry.".
In the third sentence of bullet 3) replace "only be present" with "be present only". In the fourth sentence of bullet 3) replace
e
"If it is omitted with "If this component is omitted.
Add a new last paragraph:
"Where an attribute of the type specified in an attribute-selection is supported by the MS, but is absent from a particular entry,
or is not applicable to an entry of that entry-type
...