Utility-interconnected photovoltaic inverters - Test procedure for over voltage ride-through measurements

IEC TS 63217:2021 provides a test procedure for evaluating the performance of Over Voltage Ride-Through (OVRT) functions in inverters used in utility-interconnected photovoltaic (PV) systems.
This document is most applicable to large systems where PV inverters are connected to utility high voltage (HV) distribution systems. However, the applicable procedures may also be used for low voltage (LV) installations in locations where evolving OVRT requirements include such installations, e.g. single-phase or 3-phase systems. This document is for testing of PV inverters, though it contains information that may also be useful for testing of a complete PV power plant consisting of multiple inverters connected at a single point to the utility grid. It further provides a basis for utility-interconnected PV inverters numerical simulation and model validation.

General Information

Status
Published
Publication Date
21-Nov-2021
Drafting Committee
Current Stage
PPUB - Publication issued
Start Date
22-Dec-2021
Completion Date
22-Nov-2021
Ref Project

Buy Standard

Technical specification
IEC TS 63217:2021 - Utility-interconnected photovoltaic inverters - Test procedure for over voltage ride-through measurements
English language
22 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)


IEC TS 63217 ®
Edition 1.0 2021-11
TECHNICAL
SPECIFICATION
colour
inside
Utility-interconnected photovoltaic inverters – Test procedure for over voltage
ride-through measurements
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester. If you have any questions about IEC
copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or
your local IEC member National Committee for further information.

IEC Central Office Tel.: +41 22 919 02 11
3, rue de Varembé info@iec.ch
CH-1211 Geneva 20 www.iec.ch
Switzerland
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigendum or an amendment might have been published.

IEC publications search - webstore.iec.ch/advsearchform IEC online collection - oc.iec.ch
The advanced search enables to find IEC publications by a Discover our powerful search engine and read freely all the
variety of criteria (reference number, text, technical publications previews. With a subscription you will always
committee, …). It also gives information on projects, replaced have access to up to date content tailored to your needs.
and withdrawn publications.
Electropedia - www.electropedia.org
IEC Just Published - webstore.iec.ch/justpublished
The world's leading online dictionary on electrotechnology,
Stay up to date on all new IEC publications. Just Published
containing more than 22 000 terminological entries in English
details all new publications released. Available online and
and French, with equivalent terms in 18 additional languages.
once a month by email.
Also known as the International Electrotechnical Vocabulary

(IEV) online.
IEC Customer Service Centre - webstore.iec.ch/csc

If you wish to give us your feedback on this publication or
need further assistance, please contact the Customer Service
Centre: sales@iec.ch.
IEC TS 63217 ®
Edition 1.0 2021-11
TECHNICAL
SPECIFICATION
colour
inside
Utility-interconnected photovoltaic inverters – Test procedure for over voltage

ride-through measurements
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
ICS 27.160 ISBN 978-2-8322-1051-2

– 2 – IEC TS 63217:2021 © IEC 2021
CONTENTS
FOREWORD . 4
1 Scope . 6
2 Normative references . 6
3 Terms, definitions, symbols and abbreviated terms . 7
3.1 Terms, definitions and symbols . 7
3.2 Abbreviated terms . 10
4 Test circuit and equipment . 10
4.1 General . 10
4.2 Test circuit . 10
4.3 Test equipment . 11
4.3.1 Measuring instruments. 11
4.3.2 DC source . 11
4.3.3 Multi-tap transformer . 12
4.3.4 Grid fault simulator . 12
5 Test . 14
5.1 Test protocol . 14
5.2 Test curve . 16
5.3 Test procedure . 16
5.3.1 Pre-test . 16
5.3.2 No-load test . 16
5.3.3 Tolerance . 16
5.3.4 Load test . 17
6 Assessment criteria . 17
Annex A (informative) Determination of critical performance values in OVRT testing. 18
A.1 General . 18
A.2 Ride-through time . 18
A.3 Voltage swell ratio . 18
A.4 Reactive current. 19
A.5 Active power . 19
Annex B (informative) OVRT curve and criteria . 20
B.1 General . 20
B.2 OVRT curve . 20
B.3 Test points . 20
B.4 Criteria . 21
Bibliography . 22

Figure 1 – Testing circuit diagram . 11
Figure 2 – RLC-series emulator for three-phase EUT . 12
Figure 3 – RLC-series emulator for single-phase EUT . 12
Figure 4 – Converter based emulator for three-phase EUT . 14
Figure 5 – Converter based emulator for single-phase EUT . 14
Figure 6 – OVRT curve example . 16

Figure 7 – Tolerance of voltage swell . 17
Figure A.1 – Critical performance values in OVRT testing . 18
Figure B.1 – Typical curve of OVRT . 20

Table 1 – Accuracy of measurements . 11
Table 2 – Test specification for OVRT (indicative) . 15

– 4 – IEC TS 63217:2021 © IEC 2021
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
UTILITY-INTERCONNECTED PHOTOVOLTAIC INVERTERS –
TEST PROCEDURE FOR OVER VOLTAGE RIDE-THROUGH
MEASUREMENTS
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
IEC TS 63217 has been prepared by IEC technical committee 82: Solar photovoltaic energy
systems. It is a Technical Specification.
The text of this Technical Specification is based on the following documents:
Draft Report on voting
82/1926/DTS 82/1960/RVDTS
Full information on the voting for its approval can be found in the report on voting indicated in
the above table.
The language used for the development of this Technical Specification is English.

This document was drafted in accordance with ISO/IEC Directives, Part 2, and developed in
accordance with ISO/IEC Directives, Part 1 and ISO/IEC Directives, IEC Supplement,
available at www.iec.ch/members_experts/refdocs. The main document types developed by
IEC are described in greater detail at www.iec.ch/standardsdev/publications.
The committee has decided that the contents of this document will remain unchanged until the
stability date indicated on the IEC website under webstore.iec.ch in the data related to the
specific document. At this date, the document will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
IMPORTANT – The "colour inside" logo on the cover page of this document indicates
that it contains colours which are considered to be useful for the correct
understanding of its contents. Users should therefore print this document using a
colour printer.
– 6 – IEC TS 63217:2021 © IEC 2021
UTILITY-INTERCONNECTED PHOTOVOLTAIC INVERTERS –
TEST PROCEDURE FOR OVER VOLTAGE RIDE-THROUGH
MEASUREMENTS
1 Scope
This document provides a test procedure for evaluating the performance of Over Voltage
Ride-Through (OVRT) functions in inverters used in utility-interconnected photovoltaic (PV)
systems.
This document is most applicable to large systems where PV inverters are connected to utility
high voltage (HV) distribution systems. However, the applicable procedures may also be used
for low voltage (LV) installations in locations where evolving OVRT requirements include such
installations, e.g. single-phase or 3-phase systems.
Fundamentally, the assessed OVRT performance is valid only for the specific configuratio
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.