CR 14378:2002
(Main)Ventilation for buildings - Experimental determination of mechanical energy loss coefficients of air handling components
Ventilation for buildings - Experimental determination of mechanical energy loss coefficients of air handling components
This Technical Report specifies unified test procedures and conditions for the experimental determination of mechanical energy loss coefficients for ductwork components such as ducts, bends, diffusors, converging junctions and diverging junctions.
Prezračevanje stavb – Kanali – Eksperimentalno določevanje tlačnih padcev kanalskih komponent
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST CR 14378:2002
01-maj-2002
3UH]UDþHYDQMHVWDYE±.DQDOL±(NVSHULPHQWDOQRGRORþHYDQMHWODþQLKSDGFHY
NDQDOVNLKNRPSRQHQW
Ventilation for buildings - Experimental determination of mechanical energy loss
coefficients of air handling components
Ta slovenski standard je istoveten z: CR 14378:2002
ICS:
91.140.30 3UH]UDþHYDOQLLQNOLPDWVNL Ventilation and air-
VLVWHPL conditioning
SIST CR 14378:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST CR 14378:2002
---------------------- Page: 2 ----------------------
SIST CR 14378:2002
CEN REPORT
CR 14378
RAPPORT CEN
CEN BERICHT
January 2002
ICS
English version
Ventilation for buildings - Experimental determination of
mechanical energy loss coefficients of air handling components
This CEN Report was approved by CEN on 10 November 2001. It has been drawn up by the Technical Committee CEN/TC 156.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2002 CEN All rights of exploitation in any form and by any means reserved Ref. No. CR 14378:2002 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST CR 14378:2002
CR 14378:2002 (E)
CONTENTS
Foreword.3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Test method.4
4.1 Principle.4
4.2 Test installation.6
4.3 Rectangular and other non-circular ducts and components .7
4.4 Measurements.7
4.5 Calculation method .8
4.6 Calculation of uncertainties.9
4.7 Number of test points.11
4.8 Presentation of data .11
Annex A.12
A.1 Components with inlet different from outlet (diverging or converging).12
A.2 Components with free inlets.12
A.3 Components with free outlets .13
A.4 Components with two inlets (converging junctions).14
A.5 Components with two outlets (diverging junctions).17
A.6 Components without swirl.18
Annex B .20
B.1 Flow rate measurement.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.